extcon: Add fsa9480 extcon driver

This patch adds extcon driver for Fairchild Semiconductor FSA9480
microUSB switch.
Signed-off-by: Tomasz Figa <tomasz.figa@gmail.com>
Signed-off-by: Jonathan Bakker <xc-racer2@live.ca>
Signed-off-by: Paweł Chmiel <pawel.mikolaj.chmiel@gmail.com>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>

drivers/extcon/Kconfig

@@ -37,6 +37,18 @@ config EXTCON_AXP288
 	  Say Y here to enable support for USB peripheral detection
 	  and USB MUX switching by X-Power AXP288 PMIC.
 
+config EXTCON_FSA9480
+	tristate "FSA9480 EXTCON Support"
+	depends on INPUT
+	select IRQ_DOMAIN
+	select REGMAP_I2C
+	help
+	  If you say yes here you get support for the Fairchild Semiconductor
+	  FSA9480 microUSB switch and accessory detector chip. The FSA9480 is a USB
+	  port accessory detector and switch. The FSA9480 is fully controlled using
+	  I2C and enables USB data, stereo and mono audio, video, microphone
+	  and UART data to use a common connector port.
+
 config EXTCON_GPIO
 	tristate "GPIO extcon support"
 	depends on GPIOLIB || COMPILE_TEST

drivers/extcon/Makefile

@@ -8,6 +8,7 @@ extcon-core-objs		+= extcon.o devres.o
 obj-$(CONFIG_EXTCON_ADC_JACK)	+= extcon-adc-jack.o
 obj-$(CONFIG_EXTCON_ARIZONA)	+= extcon-arizona.o
 obj-$(CONFIG_EXTCON_AXP288)	+= extcon-axp288.o
+obj-$(CONFIG_EXTCON_FSA9480)	+= extcon-fsa9480.o
 obj-$(CONFIG_EXTCON_GPIO)	+= extcon-gpio.o
 obj-$(CONFIG_EXTCON_INTEL_INT3496) += extcon-intel-int3496.o
 obj-$(CONFIG_EXTCON_INTEL_CHT_WC) += extcon-intel-cht-wc.o