Commit bb16d21c authored by Sakari Ailus's avatar Sakari Ailus Committed by Mauro Carvalho Chehab

[media] doc-rst: v4l: Add documentation on CSI-2 bus configuration

Document the interface between the CSI-2 transmitter and receiver drivers.
Signed-off-by: default avatarSakari Ailus <sakari.ailus@linux.intel.com>
Signed-off-by: default avatarMauro Carvalho Chehab <mchehab@s-opensource.com>
parent ce3aeaf2
MIPI CSI-2
==========
CSI-2 is a data bus intended for transferring images from cameras to
the host SoC. It is defined by the `MIPI alliance`_.
.. _`MIPI alliance`: http://www.mipi.org/
Transmitter drivers
-------------------
CSI-2 transmitter, such as a sensor or a TV tuner, drivers need to
provide the CSI-2 receiver with information on the CSI-2 bus
configuration. These include the V4L2_CID_LINK_FREQ and
V4L2_CID_PIXEL_RATE controls and
(:c:type:`v4l2_subdev_video_ops`->s_stream() callback). These
interface elements must be present on the sub-device represents the
CSI-2 transmitter.
The V4L2_CID_LINK_FREQ control is used to tell the receiver driver the
frequency (and not the symbol rate) of the link. The
V4L2_CID_PIXEL_RATE is may be used by the receiver to obtain the pixel
rate the transmitter uses. The
:c:type:`v4l2_subdev_video_ops`->s_stream() callback provides an
ability to start and stop the stream.
The value of the V4L2_CID_PIXEL_RATE is calculated as follows::
pixel_rate = link_freq * 2 * nr_of_lanes / bits_per_sample
where
.. list-table:: variables in pixel rate calculation
:header-rows: 1
* - variable or constant
- description
* - link_freq
- The value of the V4L2_CID_LINK_FREQ integer64 menu item.
* - nr_of_lanes
- Number of data lanes used on the CSI-2 link. This can
be obtained from the OF endpoint configuration.
* - 2
- Two bits are transferred per clock cycle per lane.
* - bits_per_sample
- Number of bits per sample.
The transmitter drivers must configure the CSI-2 transmitter to *LP-11
mode* whenever the transmitter is powered on but not active. Some
transmitters do this automatically but some have to be explicitly
programmed to do so.
Receiver drivers
----------------
Before the receiver driver may enable the CSI-2 transmitter by using
the :c:type:`v4l2_subdev_video_ops`->s_stream(), it must have powered
the transmitter up by using the
:c:type:`v4l2_subdev_core_ops`->s_power() callback. This may take
place either indirectly by using :c:func:`v4l2_pipeline_pm_use` or
directly.
......@@ -33,3 +33,4 @@ For more details see the file COPYING in the source distribution of Linux.
kapi/rc-core
kapi/mc-core
kapi/cec-core
kapi/csi2
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment