Commit bb7d9349 authored by Florian Fainelli's avatar Florian Fainelli Committed by David S. Miller

net: phy: broadcom: add helper for PHY revision and patch level

The Broadcom BCM7xxx internal PHYs do not contain any useful revision
information in the low 4-bits of their MII_PHYSID2 (MII register 3)
which could allow us to properly identify them.

As a result, we need the actual hardware block integrating these PHYs:
GENET or the SF2 switch to tell us what revision they are built with. To
assist with that, add two helper macros for fetching the the PHY
revision and patch level from the struct phy_device::dev_flags.
Signed-off-by: default avatarFlorian Fainelli <f.fainelli@gmail.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 2f637151
...@@ -41,6 +41,8 @@ ...@@ -41,6 +41,8 @@
#define PHY_BRCM_DIS_TXCRXC_NOENRGY 0x00008000 #define PHY_BRCM_DIS_TXCRXC_NOENRGY 0x00008000
/* Broadcom BCM7xxx specific workarounds */ /* Broadcom BCM7xxx specific workarounds */
#define PHY_BRCM_100MBPS_WAR 0x00010000 #define PHY_BRCM_100MBPS_WAR 0x00010000
#define PHY_BRCM_7XXX_REV(x) (((x) >> 8) & 0xff)
#define PHY_BRCM_7XXX_PATCH(x) ((x) & 0xff)
#define PHY_BCM_FLAGS_VALID 0x80000000 #define PHY_BCM_FLAGS_VALID 0x80000000
/* Broadcom BCM54XX register definitions, common to most Broadcom PHYs */ /* Broadcom BCM54XX register definitions, common to most Broadcom PHYs */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment