Commit bcc67771 authored by Shawn Guo's avatar Shawn Guo Committed by David S. Miller

net/fec: improve pm for better suspend/resume

The following commit made a fix to use fec_enet_open/fec_enet_close
over fec_enet_init/fec_stop for suspend/resume, because fec_enet_init
does not allow to have a working network interface at resume.

  e3fe8558
  net/fec: fix pm to survive to suspend/resume

This fix works for i.mx/mxc fec controller, but fails on mx28 fec
which gets a different interrupt logic design. On i.mx fec, interrupt
can be triggered even bit ETHER_EN of ECR register is not set. But
on mx28 fec, ETHER_EN must be set to get interrupt work. Meanwhile,
MII interrupt is mandatory to resume the driver, because MDIO
read/write changed to interrupt mode by commit below.

  97b72e43
  fec: use interrupt for MDIO completion indication

fec_restart/fec_stop comes out as the solution working for both
cases.
Signed-off-by: default avatarShawn Guo <shawn.guo@freescale.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 49da97dc
......@@ -1372,8 +1372,10 @@ fec_suspend(struct device *dev)
if (ndev) {
fep = netdev_priv(ndev);
if (netif_running(ndev))
fec_enet_close(ndev);
if (netif_running(ndev)) {
fec_stop(ndev);
netif_device_detach(ndev);
}
clk_disable(fep->clk);
}
return 0;
......@@ -1388,8 +1390,10 @@ fec_resume(struct device *dev)
if (ndev) {
fep = netdev_priv(ndev);
clk_enable(fep->clk);
if (netif_running(ndev))
fec_enet_open(ndev);
if (netif_running(ndev)) {
fec_restart(ndev, fep->full_duplex);
netif_device_attach(ndev);
}
}
return 0;
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment