Commit bd1637d6 authored by Michal Simek's avatar Michal Simek

microblaze: Remove additional resr and rear loading

RESR and REAR uses the same regs in whole file.
Signed-off-by: default avatarMichal Simek <monstr@monstr.eu>
parent b175bcfe
......@@ -562,20 +562,16 @@ ex_handler_done:
*/
mfs r11, rpid
nop
mfs r3, rear /* Get faulting address */
nop
/* If we are faulting a kernel address, we have to use the
* kernel page tables.
*/
ori r4, r0, CONFIG_KERNEL_START
cmpu r4, r3, r4
bgti r4, ex3
ori r5, r0, CONFIG_KERNEL_START
cmpu r5, r3, r5
bgti r5, ex3
/* First, check if it was a zone fault (which means a user
* tried to access a kernel or read-protected page - always
* a SEGV). All other faults here must be stores, so no
* need to check ESR_S as well. */
mfs r4, resr
nop
andi r4, r4, 0x800 /* ESR_Z - zone protection */
bnei r4, ex2
......@@ -590,8 +586,6 @@ ex_handler_done:
* tried to access a kernel or read-protected page - always
* a SEGV). All other faults here must be stores, so no
* need to check ESR_S as well. */
mfs r4, resr
nop
andi r4, r4, 0x800 /* ESR_Z */
bnei r4, ex2
/* get current task address */
......@@ -666,8 +660,6 @@ ex_handler_done:
* R3 = ESR
*/
mfs r3, rear /* Get faulting address */
nop
RESTORE_STATE;
bri page_fault_instr_trap
......@@ -682,8 +674,6 @@ ex_handler_done:
*/
mfs r11, rpid
nop
mfs r3, rear /* Get faulting address */
nop
/* If we are faulting a kernel address, we have to use the
* kernel page tables. */
......@@ -754,8 +744,6 @@ ex_handler_done:
*/
mfs r11, rpid
nop
mfs r3, rear /* Get faulting address */
nop
/* If we are faulting a kernel address, we have to use the
* kernel page tables.
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment