arm64: dts: exynos: fix polarity of "enable" line of NFC chip in TM2

According to s3fwrn5 driver code the "enable" GPIO line is driven "high"
when chip is not in use (mode is S3FWRN5_MODE_COLD), and is driven "low"
when chip is in use.

s3fwrn5_phy_power_ctrl():

	...
	gpio_set_value(phy->gpio_en, 1);
	...
	if (mode != S3FWRN5_MODE_COLD) {
		msleep(S3FWRN5_EN_WAIT_TIME);
		gpio_set_value(phy->gpio_en, 0);
		msleep(S3FWRN5_EN_WAIT_TIME);
	}

Therefore the line described by "en-gpios" property should be annotated
as "active low".

The wakeup gpio appears to have correct polarity (active high).
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
Link: https://lore.kernel.org/r/20220929011557.4165216-1-dmitry.torokhov@gmail.comSigned-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>

arch/arm64/boot/dts/exynos/exynos5433-tm2-common.dtsi

@@ -795,7 +795,7 @@ s3fwrn5: nfc@27 {
 		reg = <0x27>;
 		interrupt-parent = <&gpa1>;
 		interrupts = <3 IRQ_TYPE_EDGE_RISING>;
-		en-gpios = <&gpf1 4 GPIO_ACTIVE_HIGH>;
+		en-gpios = <&gpf1 4 GPIO_ACTIVE_LOW>;
 		wake-gpios = <&gpj0 2 GPIO_ACTIVE_HIGH>;
 	};
 };