Commit bd1cc771 authored by Mintz, Yuval's avatar Mintz, Yuval Committed by David S. Miller

qed: Don't close the OUT_EN during init

Before initializing the chip's engine, driver currently closes a set
of registers on the HW's ingress flow to prevent packets from slipping
in while they're not supposed to.

This configuration is insufficient, as there are some scenarios where
packets would still arrive even when said registers are set,
but the management firmware already closes other per-port registers
that do suffice, making this setting unnecessray.
Signed-off-by: default avatarYuval Mintz <Yuval.Mintz@cavium.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 60afed72
...@@ -1279,18 +1279,6 @@ static int qed_hw_init_common(struct qed_hwfn *p_hwfn, ...@@ -1279,18 +1279,6 @@ static int qed_hw_init_common(struct qed_hwfn *p_hwfn,
qed_cxt_hw_init_common(p_hwfn); qed_cxt_hw_init_common(p_hwfn);
/* Close gate from NIG to BRB/Storm; By default they are open, but
* we close them to prevent NIG from passing data to reset blocks.
* Should have been done in the ENGINE phase, but init-tool lacks
* proper port-pretend capabilities.
*/
qed_wr(p_hwfn, p_ptt, NIG_REG_RX_BRB_OUT_EN, 0);
qed_wr(p_hwfn, p_ptt, NIG_REG_STORM_OUT_EN, 0);
qed_port_pretend(p_hwfn, p_ptt, p_hwfn->port_id ^ 1);
qed_wr(p_hwfn, p_ptt, NIG_REG_RX_BRB_OUT_EN, 0);
qed_wr(p_hwfn, p_ptt, NIG_REG_STORM_OUT_EN, 0);
qed_port_unpretend(p_hwfn, p_ptt);
qed_init_cache_line_size(p_hwfn, p_ptt); qed_init_cache_line_size(p_hwfn, p_ptt);
rc = qed_init_run(p_hwfn, p_ptt, PHASE_ENGINE, ANY_PHASE_ID, hw_mode); rc = qed_init_run(p_hwfn, p_ptt, PHASE_ENGINE, ANY_PHASE_ID, hw_mode);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment