Commit bd348ca2 authored by Xingyu Wu's avatar Xingyu Wu Committed by Conor Dooley

dt-bindings: clock: Add StarFive JH7110 PLL clock generator

Add bindings for the PLL clock generator on the JH7110 RISC-V SoC.
Reviewed-by: default avatarConor Dooley <conor.dooley@microchip.com>
Reviewed-by: default avatarKrzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Signed-off-by: default avatarXingyu Wu <xingyu.wu@starfivetech.com>
Reviewed-by: default avatarEmil Renner Berthing <emil.renner.berthing@canonical.com>
Signed-off-by: default avatarConor Dooley <conor.dooley@microchip.com>
parent 06c2afb8
# SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
%YAML 1.2
---
$id: http://devicetree.org/schemas/clock/starfive,jh7110-pll.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#
title: StarFive JH7110 PLL Clock Generator
description:
These PLLs are high speed, low jitter frequency synthesizers in the JH7110.
Each PLL works in integer mode or fraction mode, with configuration
registers in the sys syscon. So the PLLs node should be a child of
SYS-SYSCON node.
The formula for calculating frequency is
Fvco = Fref * (NI + NF) / M / Q1
maintainers:
- Xingyu Wu <xingyu.wu@starfivetech.com>
properties:
compatible:
const: starfive,jh7110-pll
clocks:
maxItems: 1
description: Main Oscillator (24 MHz)
'#clock-cells':
const: 1
description:
See <dt-bindings/clock/starfive,jh7110-crg.h> for valid indices.
required:
- compatible
- clocks
- '#clock-cells'
additionalProperties: false
examples:
- |
clock-controller {
compatible = "starfive,jh7110-pll";
clocks = <&osc>;
#clock-cells = <1>;
};
......@@ -6,6 +6,12 @@
#ifndef __DT_BINDINGS_CLOCK_STARFIVE_JH7110_CRG_H__
#define __DT_BINDINGS_CLOCK_STARFIVE_JH7110_CRG_H__
/* PLL clocks */
#define JH7110_PLLCLK_PLL0_OUT 0
#define JH7110_PLLCLK_PLL1_OUT 1
#define JH7110_PLLCLK_PLL2_OUT 2
#define JH7110_PLLCLK_END 3
/* SYSCRG clocks */
#define JH7110_SYSCLK_CPU_ROOT 0
#define JH7110_SYSCLK_CPU_CORE 1
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment