dt-bindings: clock: ti: add latching support to mux and divider clocks

Certain hardware configurations, like dra76x, have some of the clock
registers partitioned in a funky manner that requires the clock
control setup to be latched for PRCM to be notified of the change. This
is accomplished with a separate control bit under the register. Add
support for this clock latching support to divider and mux clocks.
Signed-off-by: Tero Kristo <t-kristo@ti.com>
Reviewed-by: Rob Herring <robh@kernel.org>

Documentation/devicetree/bindings/clock/ti/divider.txt

@@ -75,6 +75,9 @@ Optional properties:
 - ti,invert-autoidle-bit : autoidle is enabled by setting the bit to 0,
   see [2]
 - ti,set-rate-parent : clk_set_rate is propagated to parent
+- ti,latch-bit : latch the divider value to HW, only needed if the register
+  access requires this. As an example dra76x DPLL_GMAC H14 divider implements
+  such behavior.
 
 Examples:
 dpll_usb_m2_ck: dpll_usb_m2_ck@4a008190 {

Documentation/devicetree/bindings/clock/ti/mux.txt

@@ -48,6 +48,9 @@ Optional properties:
   zero
 - ti,set-rate-parent : clk_set_rate is propagated to parent clock,
   not supported by the composite-mux-clock subtype
+- ti,latch-bit : latch the mux value to HW, only needed if the register
+  access requires this. As an example, dra7x DPLL_GMAC H14 muxing
+  implements such behavior.
 
 Examples: