md/raid1: hold the barrier until handle_read_error() finishes

handle_read_error() will call allow_barrier() to match the former barrier
raising. However, it should put the allow_barrier() at the end to avoid a
concurrent raid reshape.

Fixes: 689389a0 ("md/raid1: simplify handle_read_error().")
Reviewed-by: Yu Kuai <yukuai3@huawei.com>
Signed-off-by: Xueshi Hu <xueshi.hu@smartx.com>
Link: https://lore.kernel.org/r/20230814135356.1113639-4-xueshi.hu@smartx.comSigned-off-by: Song Liu <song@kernel.org>

drivers/md/raid1.c

@@ -2511,6 +2511,7 @@ static void handle_read_error(struct r1conf *conf, struct r1bio *r1_bio)
 	struct mddev *mddev = conf->mddev;
 	struct bio *bio;
 	struct md_rdev *rdev;
+	sector_t sector;
 
 	clear_bit(R1BIO_ReadError, &r1_bio->state);
 	/* we got a read error. Maybe the drive is bad.  Maybe just
@@ -2540,12 +2541,13 @@ static void handle_read_error(struct r1conf *conf, struct r1bio *r1_bio)
 	}
 
 	rdev_dec_pending(rdev, conf->mddev);
-	allow_barrier(conf, r1_bio->sector);
+	sector = r1_bio->sector;
 	bio = r1_bio->master_bio;
 
 	/* Reuse the old r1_bio so that the IO_BLOCKED settings are preserved */
 	r1_bio->state = 0;
 	raid1_read_request(mddev, bio, r1_bio->sectors, r1_bio);
+	allow_barrier(conf, sector);
 }
 
 static void raid1d(struct md_thread *thread)