Bluetooth: hci_bcm4377: do not mark valid bd_addr as invalid

A recent commit restored the original (and still documented) semantics
for the HCI_QUIRK_USE_BDADDR_PROPERTY quirk so that the device address
is considered invalid unless an address is provided by firmware.

This specifically means that this flag must only be set for devices with
invalid addresses, but the Broadcom BCM4377 driver has so far been
setting this flag unconditionally.

Fortunately the driver already checks for invalid addresses during setup
and sets the HCI_QUIRK_INVALID_BDADDR flag, which can simply be replaced
with HCI_QUIRK_USE_BDADDR_PROPERTY to indicate that the default address
is invalid but can be overridden by firmware (long term, this should
probably just always be allowed).

Fixes: 6945795b ("Bluetooth: fix use-bdaddr-property quirk")
Cc: stable@vger.kernel.org      # 6.5
Reported-by: Felix Zhang <mrman@mrman314.tech>
Link: https://lore.kernel.org/r/77419ffacc5b4875e920e038332575a2a5bff29f.camel@mrman314.tech/Signed-off-by: Johan Hovold <johan+linaro@kernel.org>
Reported-by: Felix Zhang <mrman@mrman314.tech>
Reviewed-by: Neal Gompa <neal@gompa.dev>
Signed-off-by: Luiz Augusto von Dentz <luiz.von.dentz@intel.com>

drivers/bluetooth/hci_bcm4377.c

@@ -1417,7 +1417,7 @@ static int bcm4377_check_bdaddr(struct bcm4377_data *bcm4377)
 
 	bda = (struct hci_rp_read_bd_addr *)skb->data;
 	if (!bcm4377_is_valid_bdaddr(bcm4377, &bda->bdaddr))
-		set_bit(HCI_QUIRK_INVALID_BDADDR, &bcm4377->hdev->quirks);
+		set_bit(HCI_QUIRK_USE_BDADDR_PROPERTY, &bcm4377->hdev->quirks);
 
 	kfree_skb(skb);
 	return 0;
@@ -2368,7 +2368,6 @@ static int bcm4377_probe(struct pci_dev *pdev, const struct pci_device_id *id)
 	hdev->set_bdaddr = bcm4377_hci_set_bdaddr;
 	hdev->setup = bcm4377_hci_setup;
 
-	set_bit(HCI_QUIRK_USE_BDADDR_PROPERTY, &hdev->quirks);
 	if (bcm4377->hw->broken_mws_transport_config)
 		set_bit(HCI_QUIRK_BROKEN_MWS_TRANSPORT_CONFIG, &hdev->quirks);
 	if (bcm4377->hw->broken_ext_scan)