ARM: dts: rockchip: add tuning related settings to veyron devices

This allows the tuning code to run and use higher speeds on capable cards.
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

arch/arm/boot/dts/rk3288-veyron-sdmmc.dtsi

@@ -90,7 +90,7 @@ &rk808 {
 	regulators {
 		vccio_sd: LDO_REG4 {
 			regulator-name = "vccio_sd";
-			regulator-min-microvolt = <3300000>;
+			regulator-min-microvolt = <1800000>;
 			regulator-max-microvolt = <3300000>;
 			regulator-state-mem {
 				regulator-off-in-suspend;
@@ -116,7 +116,12 @@ &sdmmc {
 	cap-sd-highspeed;
 	card-detect-delay = <200>;
 	cd-gpios = <&gpio7 5 GPIO_ACTIVE_LOW>;
+	rockchip,default-sample-phase = <90>;
 	num-slots = <1>;
+	sd-uhs-sdr12;
+	sd-uhs-sdr25;
+	sd-uhs-sdr50;
+	sd-uhs-sdr104;
 	vmmc-supply = <&vcc33_sd>;
 	vqmmc-supply = <&vccio_sd>;
 };

arch/arm/boot/dts/rk3288-veyron.dtsi

@@ -149,7 +149,9 @@ &emmc {
 	broken-cd;
 	bus-width = <8>;
 	cap-mmc-highspeed;
+	rockchip,default-sample-phase = <158>;
 	disable-wp;
+	mmc-hs200-1_8v;
 	mmc-pwrseq = <&emmc_pwrseq>;
 	non-removable;
 	num-slots = <1>;
@@ -355,6 +357,10 @@ &sdio0 {
 	num-slots = <1>;
 	pinctrl-names = "default";
 	pinctrl-0 = <&sdio0_clk &sdio0_cmd &sdio0_bus4>;
+	sd-uhs-sdr12;
+	sd-uhs-sdr25;
+	sd-uhs-sdr50;
+	sd-uhs-sdr104;
 	vmmc-supply = <&vcc33_sys>;
 	vqmmc-supply = <&vcc18_wl>;
 };