media: sti/bdisp: fix pm_runtime_get_sync() usage count

The pm_runtime_get_sync() internally increments the
dev->power.usage_count without decrementing it, even on errors.

The bdisp_start_streaming() doesn't take it into account, which
would unbalance PM usage counter at bdisp_stop_streaming().

The logic at bdisp_probe() is correct, but the best is to use
the same call along the driver.

So, replace it by the new pm_runtime_resume_and_get(), introduced by:
commit dd8088d5 ("PM: runtime: Add pm_runtime_resume_and_get to deal with usage counter")
in order to properly decrement the usage counter, avoiding
a potential PM usage counter leak.
Reviewed-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>

drivers/media/platform/sti/bdisp/bdisp-v4l2.c

@@ -499,7 +499,7 @@ static int bdisp_start_streaming(struct vb2_queue *q, unsigned int count)
 {
 	struct bdisp_ctx *ctx = q->drv_priv;
 	struct vb2_v4l2_buffer *buf;
-	int ret = pm_runtime_get_sync(ctx->bdisp_dev->dev);
+	int ret = pm_runtime_resume_and_get(ctx->bdisp_dev->dev);
 
 	if (ret < 0) {
 		dev_err(ctx->bdisp_dev->dev, "failed to set runtime PM\n");
@@ -1364,10 +1364,10 @@ static int bdisp_probe(struct platform_device *pdev)
 
 	/* Power management */
 	pm_runtime_enable(dev);
-	ret = pm_runtime_get_sync(dev);
+	ret = pm_runtime_resume_and_get(dev);
 	if (ret < 0) {
 		dev_err(dev, "failed to set PM\n");
-		goto err_pm;
+		goto err_remove;
 	}
 
 	/* Filters */
@@ -1395,6 +1395,7 @@ static int bdisp_probe(struct platform_device *pdev)
 	bdisp_hw_free_filters(bdisp->dev);
 err_pm:
 	pm_runtime_put(dev);
+err_remove:
 	bdisp_debugfs_remove(bdisp);
 	v4l2_device_unregister(&bdisp->v4l2_dev);
 err_clk: