wifi: ath12k: Set default beacon mode to burst mode

Currently, firmware does not like when beacon mode is set as staggered
mode for more than one beaconing vifs. Beacon mode for multiple
beaconing (transmitted) vifs are expected to be in burst mode. So set
beacon mode to burst mode by default.

Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
Signed-off-by: Sidhanta Sahu <quic_sidhanta@quicinc.com>
Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com>
Link: https://lore.kernel.org/r/20230905213943.12275-1-quic_sidhanta@quicinc.com

drivers/net/wireless/ath/ath12k/mac.c

@@ -2525,7 +2525,7 @@ static void ath12k_mac_op_bss_info_changed(struct ieee80211_hw *hw,
 
 	if (changed & BSS_CHANGED_BEACON) {
 		param_id = WMI_PDEV_PARAM_BEACON_TX_MODE;
-		param_value = WMI_BEACON_STAGGERED_MODE;
+		param_value = WMI_BEACON_BURST_MODE;
 		ret = ath12k_wmi_pdev_set_param(ar, param_id,
 						param_value, ar->pdev->pdev_id);
 		if (ret)
@@ -2533,7 +2533,7 @@ static void ath12k_mac_op_bss_info_changed(struct ieee80211_hw *hw,
 				    arvif->vdev_id);
 		else
 			ath12k_dbg(ar->ab, ATH12K_DBG_MAC,
-				   "Set staggered beacon mode for VDEV: %d\n",
+				   "Set burst beacon mode for VDEV: %d\n",
 				   arvif->vdev_id);
 
 		ret = ath12k_mac_setup_bcn_tmpl(arvif);