Merge branch 'mlxsw-enslavement'
Petr Machata says:
====================
mlxsw: Permit enslavement to netdevices with uppers
The mlxsw driver currently makes the assumption that the user applies
configuration in a bottom-up manner. Thus netdevices need to be added to
the bridge before IP addresses are configured on that bridge or SVI added
on top of it. Enslaving a netdevice to another netdevice that already has
uppers is in fact forbidden by mlxsw for this reason. Despite this safety,
it is rather easy to get into situations where the offloaded configuration
is just plain wrong.
As an example, take a front panel port, configure an IP address: it gets a
RIF. Now enslave the port to the bridge, and the RIF is gone. Remove the
port from the bridge again, but the RIF never comes back. There is a number
of similar situations, where changing the configuration there and back
utterly breaks the offload.
Similarly, detaching a front panel port from a configured topology means
unoffloading of this whole topology -- VLAN uppers, next hops, etc.
Attaching the port back is then not permitted at all. If it were, it would
not result in a working configuration, because much of mlxsw is written to
react to changes in immediate configuration. There is nothing that would go
visit netdevices in the attached-to topology and offload existing routes
and VLAN memberships, for example.
In this patchset, introduce a number of replays to be invoked so that this
sort of post-hoc offload is supported. Then remove the vetoes that
disallowed enslavement of front panel ports to other netdevices with
uppers.
The patchset progresses as follows:
- In patch #1, fix an issue in the bridge driver. To my knowledge, the
issue could not have resulted in a buggy behavior previously, and thus is
packaged with this patchset instead of being sent separately to net.
- In patch #2, add a new helper to the switchdev code.
- In patch #3, drop mlxsw selftests that will not be relevant after this
patchset anymore.
- Patches #4, #5, #6, #7 and #8 prepare the codebase for smoother
introduction of the rest of the code.
- Patches #9, #10, #11, #12, #13 and #14 replay various aspects of upper
configuration when a front panel port is introduced into a topology.
Individual patches take care of bridge and LAG RIF memberships, switchdev
replay, nexthop and neighbors replay, and MACVLAN offload.
- Patches #15 and #16 introduce RIFs for newly-relevant netdevices when a
front panel port is enslaved (in which case all uppers are newly
relevant), or, respectively, deslaved (in which case the newly-relevant
netdevice is the one being deslaved).
- Up until this point, the introduced scaffolding was not really used,
because mlxsw still forbids enslavement of mlxsw netdevices to uppers
with uppers. In patch #17, this condition is finally relaxed.
A sizable selftest suite is available to test all this new code. That will
be sent in a separate patchset.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>
Showing
This diff is collapsed.
This diff is collapsed.
Please register or sign in to comment