Commit c772a3d3 authored by Sara Sharon's avatar Sara Sharon Committed by Emmanuel Grumbach

iwlwifi: pcie: do not pad QoS AMSDU

We insert padding if the MAC header's size is not a multiple of 4
to ensure that the SNAP header is DWORD aligned. When we do so, we
let the firmware know by setting a bit in Tx command
(TX_CMD_FLG_MH_PAD) which will instruct the firmware to drop those
2 bytes before sending the frame.
However, this is not needed for AMSDU as the sub frame header (14B)
complements the MAC header (26B) so that the SNAP header is DWORD
aligned without adding any pad.

Until 9000, the firmware didn't check the TX_CMD_FLG_MH_PAD bit
but rather checked the length of the MAC header itself and
assumed the entity that enqueued the frame (driver or internal
firmware code) added the pad.
Since the driver inserted the pad even for AMSDU this logic applied.
Note that the padding is a DMA optimization but it's not strictly
needed, so we could pad even if it was not needed.

However, the CSUM hardware introduced for the 9000 devices requires
to not pad AMSDU as it is not needed, and will fail if such a pad
exists.
Due to older FW not checking the padding bit but checking the mac
header size itself - we cannot do this adjustments for older
generations.
Do not align the size if it is an AMSDU and HW checksum is enabled -
which will only happen on 9000 devices and on.
Signed-off-by: default avatarSara Sharon <sara.sharon@intel.com>
Signed-off-by: default avatarEmmanuel Grumbach <emmanuel.grumbach@intel.com>
parent 6e2611f3
......@@ -2210,6 +2210,7 @@ int iwl_trans_pcie_tx(struct iwl_trans *trans, struct sk_buff *skb,
__le16 fc;
u8 hdr_len;
u16 wifi_seq;
bool amsdu;
txq = &trans_pcie->txq[txq_id];
q = &txq->q;
......@@ -2301,11 +2302,18 @@ int iwl_trans_pcie_tx(struct iwl_trans *trans, struct sk_buff *skb,
*/
len = sizeof(struct iwl_tx_cmd) + sizeof(struct iwl_cmd_header) +
hdr_len - IWL_HCMD_SCRATCHBUF_SIZE;
tb1_len = ALIGN(len, 4);
/* Tell NIC about any 2-byte padding after MAC header */
if (tb1_len != len)
tx_cmd->tx_flags |= TX_CMD_FLG_MH_PAD_MSK;
/* do not align A-MSDU to dword as the subframe header aligns it */
amsdu = ieee80211_is_data_qos(fc) &&
(*ieee80211_get_qos_ctl(hdr) &
IEEE80211_QOS_CTL_A_MSDU_PRESENT);
if (trans_pcie->sw_csum_tx || !amsdu) {
tb1_len = ALIGN(len, 4);
/* Tell NIC about any 2-byte padding after MAC header */
if (tb1_len != len)
tx_cmd->tx_flags |= TX_CMD_FLG_MH_PAD_MSK;
} else {
tb1_len = len;
}
/* The first TB points to the scratchbuf data - min_copy bytes */
memcpy(&txq->scratchbufs[q->write_ptr], &dev_cmd->hdr,
......@@ -2323,8 +2331,7 @@ int iwl_trans_pcie_tx(struct iwl_trans *trans, struct sk_buff *skb,
goto out_err;
iwl_pcie_txq_build_tfd(trans, txq, tb1_phys, tb1_len, false);
if (ieee80211_is_data_qos(fc) &&
(*ieee80211_get_qos_ctl(hdr) & IEEE80211_QOS_CTL_A_MSDU_PRESENT)) {
if (amsdu) {
if (unlikely(iwl_fill_data_tbs_amsdu(trans, skb, txq, hdr_len,
out_meta, dev_cmd,
tb1_len)))
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment