Commit c794f6a0 authored by Sergei Shtylyov's avatar Sergei Shtylyov Committed by Simon Horman

ARM: shmobile: porter: add HS-USB DT support

Enable HS-USB device  for the Porter board, defining the GPIO that the
driver should check  when probing (which is the ID output from MAX3355
OTG chip).

Note that there  will be pinctrl-related error messages if both internal
PCI  and  HS-USB drivers are enabled but they should be just ignored.

This patch is  analogous  to the commit 6f4f7156 ("ARM: shmobile:
henninger: enable HS-USB") as there  are no differences between the
boards in this respect.
Signed-off-by: default avatarSergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Signed-off-by: default avatarSimon Horman <horms+renesas@verge.net.au>
parent 99f7445e
...@@ -269,6 +269,14 @@ &pci1 { ...@@ -269,6 +269,14 @@ &pci1 {
status = "okay"; status = "okay";
}; };
&hsusb {
pinctrl-0 = <&usb0_pins>;
pinctrl-names = "default";
status = "okay";
renesas,enable-gpio = <&gpio5 31 GPIO_ACTIVE_HIGH>;
};
&usbphy { &usbphy {
status = "okay"; status = "okay";
}; };
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment