i2c: keba: Add KEBA I2C controller support

The KEBA I2C controller is found in the system FPGA of KEBA PLC devices.
It is used to connect EEPROMs and hardware monitoring chips. The

It is a simple I2C controller with a fixed bus speed of 100 kbit/s. The
whole message transmission is executed by the driver. The driver
triggers all steps over control, status and data register. There are no
FIFOs or interrupts.
Signed-off-by: Gerhard Engleder <eg@keba.com>
Signed-off-by: Andi Shyti <andi.shyti@kernel.org>

drivers/i2c/busses/Kconfig

@@ -779,6 +779,17 @@ config I2C_JZ4780
 
 	 If you don't know what to do here, say N.
 
+config I2C_KEBA
+	tristate "KEBA I2C controller support"
+	depends on HAS_IOMEM
+	select AUXILIARY_BUS
+	help
+	  This driver supports the I2C controller found in KEBA system FPGA
+	  devices.
+
+	  This driver can also be built as a module. If so, the module
+	  will be called i2c-keba.
+
 config I2C_KEMPLD
 	tristate "Kontron COM I2C Controller"
 	depends on MFD_KEMPLD

drivers/i2c/busses/Makefile

@@ -76,6 +76,7 @@ obj-$(CONFIG_I2C_IMX)		+= i2c-imx.o
 obj-$(CONFIG_I2C_IMX_LPI2C)	+= i2c-imx-lpi2c.o
 obj-$(CONFIG_I2C_IOP3XX)	+= i2c-iop3xx.o
 obj-$(CONFIG_I2C_JZ4780)	+= i2c-jz4780.o
+obj-$(CONFIG_I2C_KEBA)		+= i2c-keba.o
 obj-$(CONFIG_I2C_KEMPLD)	+= i2c-kempld.o
 obj-$(CONFIG_I2C_LPC2K)		+= i2c-lpc2k.o
 obj-$(CONFIG_I2C_LS2X)		+= i2c-ls2x.o