wilc1000: Add support for enabling CRC

The driver so far has always disabled CRC protection.  This means any
data corruption that occurrs during the SPI transfers could go
undetected.  This patch adds module parameters enable_crc7 and
enable_crc16 to selectively turn on CRC7 (for command transfers) and
CRC16 (for data transfers), respectively.

The default configuration remains unchanged, with both CRC7 and CRC16
off.

The performance impact of CRC was measured by running ttcp -t four
times in a row on a SAMA5 device:

 CRC7 CRC16 Throughput: Standard deviation:
 ---- ----- ----------- -------------------
  off   off 1720 	+/- 48 KB/s
   on   off 1658 	+/- 58 KB/s
   on    on 1579 	+/- 84 KB/s
Signed-off-by: David Mosberger-Tang <davidm@egauge.net>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
Link: https://lore.kernel.org/r/20210227172818.1711071-4-davidm@egauge.net

drivers/net/wireless/microchip/wilc1000/Kconfig

@@ -27,6 +27,7 @@ config WILC1000_SPI
 	depends on CFG80211 && INET && SPI
 	select WILC1000
 	select CRC7
+	select CRC_ITU_T
 	help
 	  This module adds support for the SPI interface of adapters using
 	  WILC1000 chipset. The Atmel WILC1000 has a Serial Peripheral