Commit c8da642d authored by Uwe Kleine-König's avatar Uwe Kleine-König Committed by Linus Walleij

gpio: mvebu: only fail on missing clk if pwm is actually to be used

The gpio IP on Armada 370 at offset 0x18180 has neither a clk nor pwm
registers. So there is no need for a clk as the pwm isn't used anyhow.
So only check for the clk in the presence of the pwm registers. This fixes
a failure to probe the gpio driver for the above mentioned gpio device.

Fixes: 757642f9 ("gpio: mvebu: Add limited PWM support")
Signed-off-by: default avatarUwe Kleine-König <u.kleine-koenig@pengutronix.de>
Reviewed-by: default avatarGregory CLEMENT <gregory.clement@bootlin.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
parent abf221d2
...@@ -773,9 +773,6 @@ static int mvebu_pwm_probe(struct platform_device *pdev, ...@@ -773,9 +773,6 @@ static int mvebu_pwm_probe(struct platform_device *pdev,
"marvell,armada-370-gpio")) "marvell,armada-370-gpio"))
return 0; return 0;
if (IS_ERR(mvchip->clk))
return PTR_ERR(mvchip->clk);
/* /*
* There are only two sets of PWM configuration registers for * There are only two sets of PWM configuration registers for
* all the GPIO lines on those SoCs which this driver reserves * all the GPIO lines on those SoCs which this driver reserves
...@@ -786,6 +783,9 @@ static int mvebu_pwm_probe(struct platform_device *pdev, ...@@ -786,6 +783,9 @@ static int mvebu_pwm_probe(struct platform_device *pdev,
if (!res) if (!res)
return 0; return 0;
if (IS_ERR(mvchip->clk))
return PTR_ERR(mvchip->clk);
/* /*
* Use set A for lines of GPIO chip with id 0, B for GPIO chip * Use set A for lines of GPIO chip with id 0, B for GPIO chip
* with id 1. Don't allow further GPIO chips to be used for PWM. * with id 1. Don't allow further GPIO chips to be used for PWM.
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment