Merge branch 'bcmgenet-net'

Florian Fainelli says:

====================
net: bcmgenet: power management related fixes

These two patches fixes issues seen while testing power management on
platforms using the GENET driver.

First patch fixes an issue with the PHY state machine queuing work after
resume since we are not properly detached from it.

Second patch fixes an issue with GENET interfaces that were not properly
restored to a working state after a S3 suspend/resume cycle.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/genet/bcmgenet.c

@@ -2140,6 +2140,12 @@ static int bcmgenet_open(struct net_device *dev)
 		goto err_irq0;
 	}
 
+	/* Re-configure the port multiplexer towards the PHY device */
+	bcmgenet_mii_config(priv->dev, false);
+
+	phy_connect_direct(dev, priv->phydev, bcmgenet_mii_setup,
+			   priv->phy_interface);
+
 	bcmgenet_netif_start(dev);
 
 	return 0;
@@ -2184,6 +2190,9 @@ static int bcmgenet_close(struct net_device *dev)
 
 	bcmgenet_netif_stop(dev);
 
+	/* Really kill the PHY state machine and disconnect from it */
+	phy_disconnect(priv->phydev);
+
 	/* Disable MAC receive */
 	umac_enable_set(priv, CMD_RX_EN, false);
 
@@ -2685,7 +2694,7 @@ static int bcmgenet_resume(struct device *d)
 
 	phy_init_hw(priv->phydev);
 	/* Speed settings must be restored */
-	bcmgenet_mii_config(priv->dev);
+	bcmgenet_mii_config(priv->dev, false);
 
 	/* disable ethernet MAC while updating its registers */
 	umac_enable_set(priv, CMD_TX_EN | CMD_RX_EN, false);

drivers/net/ethernet/broadcom/genet/bcmgenet.h

@@ -617,9 +617,10 @@ GENET_IO_MACRO(rbuf, GENET_RBUF_OFF);
 
 /* MDIO routines */
 int bcmgenet_mii_init(struct net_device *dev);
-int bcmgenet_mii_config(struct net_device *dev);
+int bcmgenet_mii_config(struct net_device *dev, bool init);
 void bcmgenet_mii_exit(struct net_device *dev);
 void bcmgenet_mii_reset(struct net_device *dev);
+void bcmgenet_mii_setup(struct net_device *dev);
 
 /* Wake-on-LAN routines */
 void bcmgenet_get_wol(struct net_device *dev, struct ethtool_wolinfo *wol);

drivers/net/ethernet/broadcom/genet/bcmmii.c

@@ -77,7 +77,7 @@ static int bcmgenet_mii_write(struct mii_bus *bus, int phy_id,
 /* setup netdev link state when PHY link status change and
  * update UMAC and RGMII block when link up
  */
-static void bcmgenet_mii_setup(struct net_device *dev)
+void bcmgenet_mii_setup(struct net_device *dev)
 {
 	struct bcmgenet_priv *priv = netdev_priv(dev);
 	struct phy_device *phydev = priv->phydev;
@@ -211,7 +211,7 @@ static void bcmgenet_moca_phy_setup(struct bcmgenet_priv *priv)
 	bcmgenet_sys_writel(priv, reg, SYS_PORT_CTRL);
 }
 
-int bcmgenet_mii_config(struct net_device *dev)
+int bcmgenet_mii_config(struct net_device *dev, bool init)
 {
 	struct bcmgenet_priv *priv = netdev_priv(dev);
 	struct phy_device *phydev = priv->phydev;
@@ -298,7 +298,8 @@ int bcmgenet_mii_config(struct net_device *dev)
 		return -EINVAL;
 	}
 
-	dev_info(kdev, "configuring instance for %s\n", phy_name);
+	if (init)
+		dev_info(kdev, "configuring instance for %s\n", phy_name);
 
 	return 0;
 }
@@ -350,7 +351,7 @@ static int bcmgenet_mii_probe(struct net_device *dev)
 	 * PHY speed which is needed for bcmgenet_mii_config() to configure
 	 * things appropriately.
 	 */
-	ret = bcmgenet_mii_config(dev);
+	ret = bcmgenet_mii_config(dev, true);
 	if (ret) {
 		phy_disconnect(priv->phydev);
 		return ret;