Commit cacfa255 authored by Mathias Nyman's avatar Mathias Nyman Committed by Greg Kroah-Hartman

xhci: Prevent U1/U2 link pm states if exit latency is too long

commit 0472bf06 upstream.

Don't allow USB3 U1 or U2 if the latency to wake up from the U-state
reaches the service interval for a periodic endpoint.

This is according to xhci 1.1 specification section 4.23.5.2 extra note:

"Software shall ensure that a device is prevented from entering a U-state
 where its worst case exit latency approaches the ESIT."

Allowing too long exit latencies for periodic endpoint confuses xHC
internal scheduling, and new devices may fail to enumerate with a
"Not enough bandwidth for new device state" error from the host.

Cc: <stable@vger.kernel.org>
Signed-off-by: default avatarMathias Nyman <mathias.nyman@linux.intel.com>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 3ff01312
......@@ -4381,6 +4381,14 @@ static u16 xhci_calculate_u1_timeout(struct xhci_hcd *xhci,
{
unsigned long long timeout_ns;
/* Prevent U1 if service interval is shorter than U1 exit latency */
if (usb_endpoint_xfer_int(desc) || usb_endpoint_xfer_isoc(desc)) {
if (xhci_service_interval_to_ns(desc) <= udev->u1_params.mel) {
dev_dbg(&udev->dev, "Disable U1, ESIT shorter than exit latency\n");
return USB3_LPM_DISABLED;
}
}
if (xhci->quirks & XHCI_INTEL_HOST)
timeout_ns = xhci_calculate_intel_u1_timeout(udev, desc);
else
......@@ -4437,6 +4445,14 @@ static u16 xhci_calculate_u2_timeout(struct xhci_hcd *xhci,
{
unsigned long long timeout_ns;
/* Prevent U2 if service interval is shorter than U2 exit latency */
if (usb_endpoint_xfer_int(desc) || usb_endpoint_xfer_isoc(desc)) {
if (xhci_service_interval_to_ns(desc) <= udev->u2_params.mel) {
dev_dbg(&udev->dev, "Disable U2, ESIT shorter than exit latency\n");
return USB3_LPM_DISABLED;
}
}
if (xhci->quirks & XHCI_INTEL_HOST)
timeout_ns = xhci_calculate_intel_u2_timeout(udev, desc);
else
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment