staging: wlags49_h2: Fix typo in staging/wlags49_h2 driver

Correct spelling typo in staging/wlags49_h2
Signed-off-by: Masanari Iida <standby24x7@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/staging/wlags49_h2/README.ubuntu

@@ -81,7 +81,7 @@ The linux driver files (wl_xxxx.c) are changed in the following ways:
 - Addaptations of Andrey Borzenkov applied to 7.22 source
 - Alterations to avoid most HCF_ASSERTs
 -- Switching interrupts off and on in the HCF
--- Bugfixes, things that were aparently wrong like reporting link status
+-- Bugfixes, things that were apparently wrong like reporting link status
    change which checked a variable that was not changed in HCF anymore.
 -- Used on WEP but setting keys via SIOCSIWENCODEEXT was not supported
 -- Recovery actions added

drivers/staging/wlags49_h2/hcfcfg.h

@@ -21,7 +21,7 @@
 * hcfcfg.tpl list all #defines which must be specified to:
 *   adjust the HCF functions defined in HCF.C to the characteristics of a specific environment
 *		o maximum sizes for messages
-*		o Endianess
+*		o Endianness
 *	Compiler specific macros
 *		o port I/O macros
 *		o type definitions

drivers/staging/wlags49_h2/hcfdef.h

@@ -652,15 +652,15 @@ err: you used an invalid bitmask;
 #if 0 //get compiler going
 #if HCF_EX_INT_TICK != HREG_EV_TICK
 ;? out dated checking
-err: someone redefined these macros while the implemenation assumes they are equal;
+err: someone redefined these macros while the implementation assumes they are equal;
 #endif
 #if HCF_EX_INT_TX_OK != HFS_TX_CNTL_TX_OK || HFS_TX_CNTL_TX_OK != HREG_EV_TX_OK
 ;? out dated checking
-err: someone redefined these macros while the implemenation assumes they are equal;
+err: someone redefined these macros while the implementation assumes they are equal;
 #endif
 #if HCF_EX_INT_TX_EX != HFS_TX_CNTL_TX_EX || HFS_TX_CNTL_TX_EX != HREG_EV_TX_EX
 ;? out dated checking
-err: someone redefined these macros while the implemenation assumes they are equal;
+err: someone redefined these macros while the implementation assumes they are equal;
 #endif
 #endif // 0 get compiler going
 

drivers/staging/wlags49_h2/mdd.h

@@ -844,13 +844,13 @@ XX1( CFG_SCAN,					SCAN_RS_STRCT, scan_result[32]		 ) /*Scan results											*
 
 
 #define HCF_SUCCESS					0x00	// OK
-#define HCF_ERR_TIME_OUT			0x04	// Expected Hermes event did not occure in expected time
+#define HCF_ERR_TIME_OUT			0x04	// Expected Hermes event did not occur in expected time
 #define HCF_ERR_NO_NIC				0x05	/* card not found (usually yanked away during hcfio_in_string
 										  	 * Also: card is either absent or disabled while it should be neither */
 #define HCF_ERR_LEN					0x08	/* buffer size insufficient
 		 								  	 *		  -	IFB_ConfigTable too small
 		 								  	 *		  -	hcf_get_info buffer has a size of 0 or 1 or less than needed
-		 							  		 *			to accomodate all data
+		 							  		 *			to accommodate all data
 		 							  		 *		  -	hcf_put_info: CFG_DLNV_DATA exceeds intermediate
 											 *		  buffer size */
 #define HCF_ERR_INCOMP_PRI			0x09	// primary functions are not compatible

drivers/staging/wlags49_h2/wl_if.h

@@ -95,7 +95,7 @@
 //              Manufacture ID: 0156,0003
 // Lowest measurment for noise floor seen is value 54
 // Highest signal strength in close proximity to the AP seen is value 118
-// Very good must be arround 100 (otherwise its never "full scale"
+// Very good must be around 100 (otherwise its never "full scale"
 // All other constants are derrived from these. This makes the signal gauge
 // work for me...
 #define HCF_MIN_SIGNAL_LEVEL        54

drivers/staging/wlags49_h2/wl_internal.h

@@ -11,7 +11,7 @@
  *
  *------------------------------------------------------------------------------
  *
- *   Header for defintions and macros internal to the drvier.
+ *   Header for definitions and macros internal to the drvier.
  *
  *------------------------------------------------------------------------------
  *

drivers/staging/wlags49_h2/wl_main.c

@@ -128,7 +128,7 @@
 #include <wl_pci.h>
 #endif  /* BUS_PCI */
 /*******************************************************************************
- *	macro defintions
+ *	macro definitions
  ******************************************************************************/
 #define VALID_PARAM(C) \
 	{ \
@@ -1627,7 +1627,7 @@ int wl_put_ltv( struct wl_private *lp )
 		lp->ltvRecord.u.u16[0]  = CNV_INT_TO_LITTLE( lp->TxRateControl[0] );
 #endif  // WARP
 
-//;?skip temporarily to see whether the RID or something else is the probelm hcf_status = hcf_put_info( &lp->hcfCtx, (LTVP)&( lp->ltvRecord ));
+//;?skip temporarily to see whether the RID or something else is the problem hcf_status = hcf_put_info( &lp->hcfCtx, (LTVP)&( lp->ltvRecord ));
 
 		DBG_TRACE( DbgInfo, "CFG_TX_RATE_CNTL 2.4GHz           : 0x%04x\n",
 				   lp->TxRateControl[0] );

drivers/staging/wlags49_h2/wl_netdev.c

@@ -1251,7 +1251,7 @@ struct net_device * wl_device_alloc( void )
 
     netif_stop_queue( dev );
 
-    /* Allocate virutal devices for WDS support if needed */
+    /* Allocate virtual devices for WDS support if needed */
     WL_WDS_DEVICE_ALLOC( lp );
 
     DBG_LEAVE( DbgInfo );

drivers/staging/wlags49_h2/wl_pci.c

@@ -385,7 +385,7 @@ int wl_adapter_is_open( struct net_device *dev )
  *  DESCRIPTION:
  *
  *      Registered in the pci_driver structure, this function is called when the
- *  PCI subsystem finds a new PCI device which matches the infomation contained
+ *  PCI subsystem finds a new PCI device which matches the information contained
  *  in the pci_device_id table.
  *
  *  PARAMETERS:
@@ -424,7 +424,7 @@ int __devinit wl_pci_probe( struct pci_dev *pdev,
  *  DESCRIPTION:
  *
  *      Registered in the pci_driver structure, this function is called when the
- *  PCI subsystem detects that a PCI device which matches the infomation
+ *  PCI subsystem detects that a PCI device which matches the information
  *  contained in the pci_device_id table has been removed.
  *
  *  PARAMETERS:

drivers/staging/wlags49_h2/wl_priv.c

@@ -225,7 +225,7 @@ int wvlan_uil_connect( struct uilreq *urq, struct wl_private *lp )
  *
  *  DESCRIPTION:
  *
- *      Disonnect from the UIL after a request has been completed.
+ *      Disconnect from the UIL after a request has been completed.
  *
  *  PARAMETERS:
  *

drivers/staging/wlags49_h2/wl_profile.c

@@ -910,7 +910,7 @@ int parse_mac_address(char *value, u_char *byte_array)
 	memset(byte_field, '\0', 3);
 
 	while (value[value_offset] != '\0') {
-		/* Skip over the colon chars seperating the bytes, if they exist */
+		/* Skip over the colon chars separating the bytes, if they exist */
 		if (value[value_offset] == ':') {
 			value_offset++;
 			continue;

drivers/staging/wlags49_h2/wl_version.h

@@ -152,7 +152,7 @@ err: define bus type;
 
 
 /*******************************************************************************
- *  bus architechture specific defines, includes, etc.
+ *  bus architecture specific defines, includes, etc.
  ******************************************************************************/
 /*
  * There doesn't seem to be a difference for PCMCIA and PCI anymore, at least

drivers/staging/wlags49_h2/wl_wext.c

@@ -2595,7 +2595,7 @@ static int wireless_set_scan(struct net_device *dev, struct iw_request_info *inf
 	int		    retries = 0;
 	/*------------------------------------------------------------------------*/
 
-	//;? Note: shows results as trace, retruns always 0 unless BUSY
+	//;? Note: shows results as trace, returns always 0 unless BUSY
 
 	DBG_FUNC( "wireless_set_scan" );
 	DBG_ENTER( DbgInfo );