Commit cb8ca589 authored by Zumeng Chen's avatar Zumeng Chen Committed by Tony Lindgren

ARM: omap3evm: enable VBUS switch for EHCI tranceiver

This was chosen by following the trace on the schematic from component U131
and U134 to the CPEN pin on the USB3320 device.

TWL4030.GPIO2-...->(T2_GPIO2_3V3)U131-..>nUSB2_EN-..>U134-..>EXP_nUSB2_1V8
which starts EHCI tranceiver USB3320.

This will set TWL4030.GPIO2 as output pin to drive EHCI tranceiver.
Signed-off-by: default avatarZumeng Chen <zumeng.chen@windriver.com>
Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
parent 497af1f3
...@@ -360,6 +360,17 @@ static int omap3evm_twl_gpio_setup(struct device *dev, ...@@ -360,6 +360,17 @@ static int omap3evm_twl_gpio_setup(struct device *dev,
platform_device_register(&leds_gpio); platform_device_register(&leds_gpio);
/* Enable VBUS switch by setting TWL4030.GPIO2DIR as output
* for starting USB tranceiver
*/
if (get_omap3_evm_rev() >= OMAP3EVM_BOARD_GEN_2) {
u8 val;
twl_i2c_read_u8(TWL4030_MODULE_GPIO, &val, REG_GPIODATADIR1);
val |= 0x04; /* TWL4030.GPIO2DIR BIT at GPIODATADIR1(0x9B) */
twl_i2c_write_u8(TWL4030_MODULE_GPIO, val, REG_GPIODATADIR1);
}
return 0; return 0;
} }
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment