drivers/serial: Do not leave sysfs group in case of error in aspeed_vuart_probe()

There are several error handling paths in aspeed_vuart_probe(),
where sysfs group is left unremoved. The patch fixes them.

Found by Linux Driver Verification project (linuxtesting.org).
Signed-off-by: Alexey Khoroshilov <khoroshilov@ispras.ru>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/tty/serial/8250/8250_aspeed_vuart.c

@@ -223,12 +223,13 @@ static int aspeed_vuart_probe(struct platform_device *pdev)
 		if (IS_ERR(vuart->clk)) {
 			dev_warn(&pdev->dev,
 				"clk or clock-frequency not defined\n");
-			return PTR_ERR(vuart->clk);
+			rc = PTR_ERR(vuart->clk);
+			goto err_sysfs_remove;
 		}
 
 		rc = clk_prepare_enable(vuart->clk);
 		if (rc < 0)
-			return rc;
+			goto err_sysfs_remove;
 
 		clk = clk_get_rate(vuart->clk);
 	}
@@ -286,6 +287,8 @@ static int aspeed_vuart_probe(struct platform_device *pdev)
 err_clk_disable:
 	clk_disable_unprepare(vuart->clk);
 	irq_dispose_mapping(port.port.irq);
+err_sysfs_remove:
+	sysfs_remove_group(&vuart->dev->kobj, &aspeed_vuart_attr_group);
 	return rc;
 }