ASoC: davinci-mcasp: Data source (bus) selection support

The audio data to/from McASP can be sent/received via two method:
Via the data port (preferred) or via the configuration bus.
Currently the driver assumes that all data communication will be done via
the data port.
This patch adds support for selecting the configuration port as data
interface.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@linaro.org>

sound/soc/davinci/davinci-mcasp.c

@@ -53,6 +53,8 @@ struct davinci_mcasp {
 	u8	txnumevt;
 	u8	rxnumevt;
 
+	bool	dat_port;
+
 #ifdef CONFIG_PM_SLEEP
 	struct {
 		u32	txfmtctl;
@@ -482,6 +484,7 @@ static void davinci_hw_param(struct davinci_mcasp *mcasp, int stream)
 {
 	int i, active_slots;
 	u32 mask = 0;
+	u32 busel = 0;
 
 	active_slots = (mcasp->tdm_slots > 31) ? 32 : mcasp->tdm_slots;
 	for (i = 0; i < active_slots; i++)
@@ -489,11 +492,15 @@ static void davinci_hw_param(struct davinci_mcasp *mcasp, int stream)
 
 	mcasp_clr_bits(mcasp->base + DAVINCI_MCASP_ACLKXCTL_REG, TX_ASYNC);
 
+	if (!mcasp->dat_port)
+		busel = TXSEL;
+
 	if (stream == SNDRV_PCM_STREAM_PLAYBACK) {
 		/* bit stream is MSB first  with no delay */
 		/* DSP_B mode */
 		mcasp_set_reg(mcasp->base + DAVINCI_MCASP_TXTDM_REG, mask);
-		mcasp_set_bits(mcasp->base + DAVINCI_MCASP_TXFMT_REG, TXORD);
+		mcasp_set_bits(mcasp->base + DAVINCI_MCASP_TXFMT_REG,
+			       busel | TXORD);
 
 		if ((mcasp->tdm_slots >= 2) && (mcasp->tdm_slots <= 32))
 			mcasp_mod_bits(mcasp->base + DAVINCI_MCASP_TXFMCTL_REG,
@@ -504,7 +511,8 @@ static void davinci_hw_param(struct davinci_mcasp *mcasp, int stream)
 	} else {
 		/* bit stream is MSB first with no delay */
 		/* DSP_B mode */
-		mcasp_set_bits(mcasp->base + DAVINCI_MCASP_RXFMT_REG, RXORD);
+		mcasp_set_bits(mcasp->base + DAVINCI_MCASP_RXFMT_REG,
+			       busel | RXORD);
 		mcasp_set_reg(mcasp->base + DAVINCI_MCASP_RXTDM_REG, mask);
 
 		if ((mcasp->tdm_slots >= 2) && (mcasp->tdm_slots <= 32))
@@ -928,23 +936,22 @@ static int davinci_mcasp_probe(struct platform_device *pdev)
 	mcasp->version = pdata->version;
 	mcasp->txnumevt = pdata->txnumevt;
 	mcasp->rxnumevt = pdata->rxnumevt;
-	if (mcasp->version < MCASP_VERSION_3)
-		mcasp->fifo_base = DAVINCI_MCASP_V2_AFIFO_BASE;
-	else
-		mcasp->fifo_base = DAVINCI_MCASP_V3_AFIFO_BASE;
 
 	mcasp->dev = &pdev->dev;
 
 	dat = platform_get_resource_byname(pdev, IORESOURCE_MEM, "dat");
-	if (!dat)
-		dat = mem;
+	if (dat)
+		mcasp->dat_port = true;
 
 	dma_data = &mcasp->dma_params[SNDRV_PCM_STREAM_PLAYBACK];
 	dma_data->asp_chan_q = pdata->asp_chan_q;
 	dma_data->ram_chan_q = pdata->ram_chan_q;
 	dma_data->sram_pool = pdata->sram_pool;
 	dma_data->sram_size = pdata->sram_size_playback;
-	dma_data->dma_addr = dat->start + pdata->tx_dma_offset;
+	if (dat)
+		dma_data->dma_addr = dat->start;
+	else
+		dma_data->dma_addr = mem->start + pdata->tx_dma_offset;
 
 	res = platform_get_resource(pdev, IORESOURCE_DMA, 0);
 	if (res)
@@ -957,7 +964,18 @@ static int davinci_mcasp_probe(struct platform_device *pdev)
 	dma_data->ram_chan_q = pdata->ram_chan_q;
 	dma_data->sram_pool = pdata->sram_pool;
 	dma_data->sram_size = pdata->sram_size_capture;
-	dma_data->dma_addr = dat->start + pdata->rx_dma_offset;
+	if (dat)
+		dma_data->dma_addr = dat->start;
+	else
+		dma_data->dma_addr = mem->start + pdata->rx_dma_offset;
+
+	if (mcasp->version < MCASP_VERSION_3) {
+		mcasp->fifo_base = DAVINCI_MCASP_V2_AFIFO_BASE;
+		/* dma_data->dma_addr is pointing to the data port address */
+		mcasp->dat_port = true;
+	} else {
+		mcasp->fifo_base = DAVINCI_MCASP_V3_AFIFO_BASE;
+	}
 
 	res = platform_get_resource(pdev, IORESOURCE_DMA, 1);
 	if (res)