Commit cbf6bae1 authored by Anders Hedlund's avatar Anders Hedlund Committed by Tony Lindgren

ARM: OMAP3: igep0020: Set WIFI/BT GPIO pins in correct mux mode

Setup the WIFI/BT GPIO pin muxes to enable WIFI/BT functionality.

This is needed to fix regression caused by recent versions of
u-boot that only mux essential pins.
Signed-off-by: default avatarAnders Hedlund <anders.j.hedlund@gmail.com>
Cc: Jonas Zetterberg <jozz@jozz.se>
Cc: Enric Balletbo i Serra <eballetbo@gmail.com>
Cc: Javier Martinez Canillas <martinez.javier@gmail.com>
Cc: Matthias Brugger <mbrugger@iseebcn.com>
[tony@atomide.com: updated comments to describe regression]
Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
parent 5e767ab9
...@@ -580,6 +580,11 @@ static void __init igep_wlan_bt_init(void) ...@@ -580,6 +580,11 @@ static void __init igep_wlan_bt_init(void)
} else } else
return; return;
/* Make sure that the GPIO pins are muxed correctly */
omap_mux_init_gpio(igep_wlan_bt_gpios[0].gpio, OMAP_PIN_OUTPUT);
omap_mux_init_gpio(igep_wlan_bt_gpios[1].gpio, OMAP_PIN_OUTPUT);
omap_mux_init_gpio(igep_wlan_bt_gpios[2].gpio, OMAP_PIN_OUTPUT);
err = gpio_request_array(igep_wlan_bt_gpios, err = gpio_request_array(igep_wlan_bt_gpios,
ARRAY_SIZE(igep_wlan_bt_gpios)); ARRAY_SIZE(igep_wlan_bt_gpios));
if (err) { if (err) {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment