Commit cc92ade5 authored by shaoyunl's avatar shaoyunl Committed by Greg Kroah-Hartman

drm/amdgpu: Add delay after enable RLC ucode

[ Upstream commit ad97d9de ]

Driver shouldn't try to access any GFX registers until RLC is idle.
During the test, it took 12 seconds for RLC to clear the BUSY bit
in RLC_GPM_STAT register which is un-acceptable for driver.
As per RLC engineer, it would take RLC Ucode less than 10,000 GFXCLK
cycles to finish its critical section. In a lowest 300M enginer clock
setting(default from vbios), 50 us delay is enough.

This commit fix the hang when RLC introduce the work around for XGMI
which requires more cycles to setup more registers than normal
Signed-off-by: default avatarshaoyunl <shaoyun.liu@amd.com>
Acked-by: default avatarFelix Kuehling <Felix.Kuehling@amd.com>
Signed-off-by: default avatarAlex Deucher <alexander.deucher@amd.com>
Signed-off-by: default avatarSasha Levin <sashal@kernel.org>
parent 8a69edb8
......@@ -1992,12 +1992,13 @@ static void gfx_v9_0_rlc_start(struct amdgpu_device *adev)
#endif
WREG32_FIELD15(GC, 0, RLC_CNTL, RLC_ENABLE_F32, 1);
udelay(50);
/* carrizo do enable cp interrupt after cp inited */
if (!(adev->flags & AMD_IS_APU))
if (!(adev->flags & AMD_IS_APU)) {
gfx_v9_0_enable_gui_idle_interrupt(adev, true);
udelay(50);
udelay(50);
}
#ifdef AMDGPU_RLC_DEBUG_RETRY
/* RLC_GPM_GENERAL_6 : RLC Ucode version */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment