Commit ce206708 authored by Qiuxu Zhuo's avatar Qiuxu Zhuo Committed by Tony Luck

EDAC/i10nm: Update driver to support different bus number config register offsets

The i10nm_edac driver failed to load on Ice Lake and Tremont/Jacobsville
servers if their CPU stepping >= 4 and failed on Ice Lake-D servers from
stepping 0. The root cause was that for Ice Lake and Tremont/Jacobsville
servers with CPU stepping >=4, the offset for bus number configuration
register was updated from 0xcc to 0xd0. For Ice Lake-D servers, all the
steppings use the updated 0xd0 offset.

Fix the issue by using the appropriate offset for bus number
configuration register according to the CPU model number and stepping.
Reported-by: default avatarJerry Chen <jerry.t.chen@intel.com>
Reported-and-tested-by: default avatarJin Wen <wen.jin@intel.com>
Signed-off-by: default avatarQiuxu Zhuo <qiuxu.zhuo@intel.com>
Signed-off-by: default avatarTony Luck <tony.luck@intel.com>
Reviewed-by: default avatarBorislav Petkov <bp@suse.de>
Link: https://lore.kernel.org/linux-edac/20200427084022.GC11036@zn.tnic
parent ee5340ab
......@@ -122,16 +122,22 @@ static int i10nm_get_all_munits(void)
return 0;
}
static struct res_config i10nm_cfg = {
static struct res_config i10nm_cfg0 = {
.type = I10NM,
.decs_did = 0x3452,
.busno_cfg_offset = 0xcc,
};
static struct res_config i10nm_cfg1 = {
.type = I10NM,
.decs_did = 0x3452,
.busno_cfg_offset = 0xd0,
};
static const struct x86_cpu_id i10nm_cpuids[] = {
X86_MATCH_INTEL_FAM6_MODEL(ATOM_TREMONT_D, &i10nm_cfg),
X86_MATCH_INTEL_FAM6_MODEL(ICELAKE_X, &i10nm_cfg),
X86_MATCH_INTEL_FAM6_MODEL(ICELAKE_D, &i10nm_cfg),
X86_MATCH_INTEL_FAM6_MODEL(ATOM_TREMONT_D, &i10nm_cfg0),
X86_MATCH_INTEL_FAM6_MODEL(ICELAKE_X, &i10nm_cfg0),
X86_MATCH_INTEL_FAM6_MODEL(ICELAKE_D, &i10nm_cfg1),
{}
};
MODULE_DEVICE_TABLE(x86cpu, i10nm_cpuids);
......@@ -258,6 +264,10 @@ static int __init i10nm_init(void)
cfg = (struct res_config *)id->driver_data;
/* Newer steppings have different offset for ATOM_TREMONT_D/ICELAKE_X */
if (boot_cpu_data.x86_stepping >= 4)
cfg->busno_cfg_offset = 0xd0;
rc = skx_get_hi_lo(0x09a2, off, &tolm, &tohm);
if (rc)
return rc;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment