Commit ceaa0a6e authored by Yoshihiro Shimoda's avatar Yoshihiro Shimoda Committed by Felipe Balbi

usb: gadget: m66592-udc: add support for TEST_MODE

The USB high speed device must support the TEST_MODE, but the driver
didn't support it. When we sent the SET_FEATURE for TEST_MODE to
the driver, the request was successful, but the module didn't enter
the TEST_MODE.
Signed-off-by: default avatarYoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Signed-off-by: default avatarFelipe Balbi <balbi@ti.com>
parent 5154e9f1
...@@ -691,6 +691,7 @@ static void init_controller(struct m66592 *m66592) ...@@ -691,6 +691,7 @@ static void init_controller(struct m66592 *m66592)
static void disable_controller(struct m66592 *m66592) static void disable_controller(struct m66592 *m66592)
{ {
m66592_bclr(m66592, M66592_UTST, M66592_TESTMODE);
if (!m66592->pdata->on_chip) { if (!m66592->pdata->on_chip) {
m66592_bclr(m66592, M66592_SCKE, M66592_SYSCFG); m66592_bclr(m66592, M66592_SCKE, M66592_SYSCFG);
udelay(1); udelay(1);
...@@ -1048,10 +1049,30 @@ static void clear_feature(struct m66592 *m66592, struct usb_ctrlrequest *ctrl) ...@@ -1048,10 +1049,30 @@ static void clear_feature(struct m66592 *m66592, struct usb_ctrlrequest *ctrl)
static void set_feature(struct m66592 *m66592, struct usb_ctrlrequest *ctrl) static void set_feature(struct m66592 *m66592, struct usb_ctrlrequest *ctrl)
{ {
u16 tmp;
int timeout = 3000;
switch (ctrl->bRequestType & USB_RECIP_MASK) { switch (ctrl->bRequestType & USB_RECIP_MASK) {
case USB_RECIP_DEVICE: case USB_RECIP_DEVICE:
control_end(m66592, 1); switch (le16_to_cpu(ctrl->wValue)) {
case USB_DEVICE_TEST_MODE:
control_end(m66592, 1);
/* Wait for the completion of status stage */
do {
tmp = m66592_read(m66592, M66592_INTSTS0) &
M66592_CTSQ;
udelay(1);
} while (tmp != M66592_CS_IDST || timeout-- > 0);
if (tmp == M66592_CS_IDST)
m66592_bset(m66592,
le16_to_cpu(ctrl->wIndex >> 8),
M66592_TESTMODE);
break;
default:
pipe_stall(m66592, 0);
break;
}
break; break;
case USB_RECIP_INTERFACE: case USB_RECIP_INTERFACE:
control_end(m66592, 1); control_end(m66592, 1);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment