Commit d046f611 authored by Greg Ungerer's avatar Greg Ungerer Committed by Linus Torvalds

[PATCH] m68knommu: use Kconfig RAM config options in 68360 RAM startup code

Switch to using the new RAM Kconfig settings, instead of linker defined
regions in RAM specific 68360 startup code.
Signed-off-by: default avatarGreg Ungerer <gerg@uclinux.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@osdl.org>
parent 999567d8
......@@ -18,7 +18,6 @@
.global _start
.global _rambase
.global __ramvec
.global _ramvec
.global _ramstart
.global _ramend
......@@ -26,6 +25,8 @@
.global _quicc_base
.global _periph_base
#define RAMEND (CONFIG_RAMBASE + CONFIG_RAMSIZE)
#define REGB 0x1000
#define PEPAR (_dprbase + REGB + 0x0016)
#define GMR (_dprbase + REGB + 0x0040)
......@@ -103,7 +104,7 @@ _stext:
nop
ori.w #MCU_DISABLE_INTRPTS, %sr /* disable interrupts: */
/* We should not need to setup the boot stack the reset should do it. */
movea.l #__ramend, %sp /*set up stack at the end of DRAM:*/
movea.l #RAMEND, %sp /*set up stack at the end of DRAM:*/
set_mbar_register:
moveq.l #0x07, %d1 /* Setup MBAR */
......@@ -163,7 +164,7 @@ configure_memory_controller:
move.l %d0, GMR
configure_chip_select_0:
move.l #__ramend, %d0
move.l #RAMEND, %d0
subi.l #__ramstart, %d0
subq.l #0x01, %d0
eori.l #SIM_OR_MASK, %d0
......@@ -234,16 +235,10 @@ store_ram_size:
/* Set ram size information */
move.l #_sdata, _rambase
move.l #_ebss, _ramstart
move.l #__ramend, %d0
move.l #RAMEND, %d0
sub.l #0x1000, %d0 /* Reserve 4K for stack space.*/
move.l %d0, _ramend /* Different from __ramend.*/
move.l %d0, _ramend /* Different from RAMEND.*/
store_flash_size:
/* Set rom size information */
move.l #__rom_end, %d0
sub.l #__rom_start, %d0
move.l %d0, rom_length
pea 0
pea env
pea %sp@(4)
......@@ -286,7 +281,7 @@ _dprbase:
*/
.section ".data.initvect","awx"
.long __ramend /* Reset: Initial Stack Pointer - 0. */
.long RAMEND /* Reset: Initial Stack Pointer - 0. */
.long _start /* Reset: Initial Program Counter - 1. */
.long buserr /* Bus Error - 2. */
.long trap /* Address Error - 3. */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment