Commit d0c6a347 authored by Pali Rohár's avatar Pali Rohár Committed by Lorenzo Pieralisi

PCI: aardvark: Move PCIe reset card code to advk_pcie_train_link()

Move code which belongs to link training (delays and resets) into
advk_pcie_train_link() function, so everything related to link training,
including timings is at one place.

After experiments it can be observed that link training in aardvark
hardware is very sensitive to timings and delays, so it is a good idea to
have this code at the same place as link training calls.

This patch does not change behavior of aardvark initialization.

Link: https://lore.kernel.org/r/20200907111038.5811-6-pali@kernel.orgTested-by: default avatarMarek Behún <marek.behun@nic.cz>
Signed-off-by: default avatarPali Rohár <pali@kernel.org>
Signed-off-by: default avatarLorenzo Pieralisi <lorenzo.pieralisi@arm.com>
parent 526a7699
...@@ -252,6 +252,25 @@ static void advk_pcie_wait_for_retrain(struct advk_pcie *pcie) ...@@ -252,6 +252,25 @@ static void advk_pcie_wait_for_retrain(struct advk_pcie *pcie)
} }
} }
static void advk_pcie_issue_perst(struct advk_pcie *pcie)
{
u32 reg;
if (!pcie->reset_gpio)
return;
/* PERST does not work for some cards when link training is enabled */
reg = advk_readl(pcie, PCIE_CORE_CTRL0_REG);
reg &= ~LINK_TRAINING_EN;
advk_writel(pcie, reg, PCIE_CORE_CTRL0_REG);
/* 10ms delay is needed for some cards */
dev_info(&pcie->pdev->dev, "issuing PERST via reset GPIO for 10ms\n");
gpiod_set_value_cansleep(pcie->reset_gpio, 1);
usleep_range(10000, 11000);
gpiod_set_value_cansleep(pcie->reset_gpio, 0);
}
static int advk_pcie_train_at_gen(struct advk_pcie *pcie, int gen) static int advk_pcie_train_at_gen(struct advk_pcie *pcie, int gen)
{ {
int ret, neg_gen; int ret, neg_gen;
...@@ -299,6 +318,21 @@ static void advk_pcie_train_link(struct advk_pcie *pcie) ...@@ -299,6 +318,21 @@ static void advk_pcie_train_link(struct advk_pcie *pcie)
struct device *dev = &pcie->pdev->dev; struct device *dev = &pcie->pdev->dev;
int neg_gen = -1, gen; int neg_gen = -1, gen;
/*
* Reset PCIe card via PERST# signal. Some cards are not detected
* during link training when they are in some non-initial state.
*/
advk_pcie_issue_perst(pcie);
/*
* PERST# signal could have been asserted by pinctrl subsystem before
* probe() callback has been called or issued explicitly by reset gpio
* function advk_pcie_issue_perst(), making the endpoint going into
* fundamental reset. As required by PCI Express spec a delay for at
* least 100ms after such a reset before link training is needed.
*/
msleep(PCI_PM_D3COLD_WAIT);
/* /*
* Try link training at link gen specified by device tree property * Try link training at link gen specified by device tree property
* 'max-link-speed'. If this fails, iteratively train at lower gen. * 'max-link-speed'. If this fails, iteratively train at lower gen.
...@@ -331,31 +365,10 @@ static void advk_pcie_train_link(struct advk_pcie *pcie) ...@@ -331,31 +365,10 @@ static void advk_pcie_train_link(struct advk_pcie *pcie)
dev_err(dev, "link never came up\n"); dev_err(dev, "link never came up\n");
} }
static void advk_pcie_issue_perst(struct advk_pcie *pcie)
{
u32 reg;
if (!pcie->reset_gpio)
return;
/* PERST does not work for some cards when link training is enabled */
reg = advk_readl(pcie, PCIE_CORE_CTRL0_REG);
reg &= ~LINK_TRAINING_EN;
advk_writel(pcie, reg, PCIE_CORE_CTRL0_REG);
/* 10ms delay is needed for some cards */
dev_info(&pcie->pdev->dev, "issuing PERST via reset GPIO for 10ms\n");
gpiod_set_value_cansleep(pcie->reset_gpio, 1);
usleep_range(10000, 11000);
gpiod_set_value_cansleep(pcie->reset_gpio, 0);
}
static void advk_pcie_setup_hw(struct advk_pcie *pcie) static void advk_pcie_setup_hw(struct advk_pcie *pcie)
{ {
u32 reg; u32 reg;
advk_pcie_issue_perst(pcie);
/* Enable TX */ /* Enable TX */
reg = advk_readl(pcie, PCIE_CORE_REF_CLK_REG); reg = advk_readl(pcie, PCIE_CORE_REF_CLK_REG);
reg |= PCIE_CORE_REF_CLK_TX_ENABLE; reg |= PCIE_CORE_REF_CLK_TX_ENABLE;
...@@ -432,15 +445,6 @@ static void advk_pcie_setup_hw(struct advk_pcie *pcie) ...@@ -432,15 +445,6 @@ static void advk_pcie_setup_hw(struct advk_pcie *pcie)
reg |= PIO_CTRL_ADDR_WIN_DISABLE; reg |= PIO_CTRL_ADDR_WIN_DISABLE;
advk_writel(pcie, reg, PIO_CTRL); advk_writel(pcie, reg, PIO_CTRL);
/*
* PERST# signal could have been asserted by pinctrl subsystem before
* probe() callback has been called or issued explicitly by reset gpio
* function advk_pcie_issue_perst(), making the endpoint going into
* fundamental reset. As required by PCI Express spec a delay for at
* least 100ms after such a reset before link training is needed.
*/
msleep(PCI_PM_D3COLD_WAIT);
advk_pcie_train_link(pcie); advk_pcie_train_link(pcie);
/* /*
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment