PCI: thunder-ecam: Make explicitly non-modular

This code is not being built as a module by anyone:

  drivers/pci/host/Kconfig:config PCI_HOST_THUNDER_ECAM
  drivers/pci/host/Kconfig:       bool "Cavium Thunder ECAM controller to on-chip devices on pass-1.x silicon"

Remove uses of MODULE_DESCRIPTION(), MODULE_AUTHOR(), MODULE_LICENSE(),
etc., so that when reading the driver there is no doubt it is builtin-only.
The information is preserved in comments at the top of the file.

Replace module_platform_driver() with builtin_platform_driver(), which uses
the same init level priority, so init ordering is unchanged.

Note that MODULE_DEVICE_TABLE is a no-op for non-modular code.

[bhelgaas: changelog]
Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
CC: David Daney <david.daney@cavium.com>

drivers/pci/host/pci-thunder-ecam.c

@@ -7,7 +7,7 @@
  */
 
 #include <linux/kernel.h>
-#include <linux/module.h>
+#include <linux/init.h>
 #include <linux/ioport.h>
 #include <linux/of_pci.h>
 #include <linux/of.h>
@@ -360,7 +360,6 @@ static const struct of_device_id thunder_ecam_of_match[] = {
 	{ .compatible = "cavium,pci-host-thunder-ecam" },
 	{ },
 };
-MODULE_DEVICE_TABLE(of, thunder_ecam_of_match);
 
 static int thunder_ecam_probe(struct platform_device *pdev)
 {
@@ -374,7 +373,4 @@ static struct platform_driver thunder_ecam_driver = {
 	},
 	.probe = thunder_ecam_probe,
 };
-module_platform_driver(thunder_ecam_driver);
-
-MODULE_DESCRIPTION("Thunder ECAM PCI host driver");
-MODULE_LICENSE("GPL v2");
+builtin_platform_driver(thunder_ecam_driver);