pinctrl: renesas: rzg2l: Add pin configuration support for pinmux groups

On RZ/G3S different Ethernet pins need to be configured with different
settings (e.g. power-source needs to be set, RGMII TXC and TX_CTL pins
need output-enable).  Adjust the driver to allow specifying pin
configuration for pinmux groups.  With this, DT settings like the
following are taken into account by the driver:

    eth0_pins: eth0 {
	    tx_ctl {
		    pinmux = <RZG2L_PORT_PINMUX(1, 1, 1)>;  /* ET0_TX_CTL */
		    power-source = <1800>;
		    output-enable;
		    drive-strength-microamp = <5200>;
	    };
    };
Signed-off-by: Claudiu Beznea <claudiu.beznea.uj@bp.renesas.com>
Reviewed-by: Geert Uytterhoeven <geert+renesas@glider.be>
Link: https://lore.kernel.org/r/20231207070700.4156557-5-claudiu.beznea.uj@bp.renesas.comSigned-off-by: Geert Uytterhoeven <geert+renesas@glider.be>

drivers/pinctrl/renesas/pinctrl-rzg2l.c

@@ -376,8 +376,11 @@ static int rzg2l_dt_subnode_to_map(struct pinctrl_dev *pctldev,
 		goto done;
 	}
 
-	if (num_pinmux)
+	if (num_pinmux) {
 		nmaps += 1;
+		if (num_configs)
+			nmaps += 1;
+	}
 
 	if (num_pins)
 		nmaps += num_pins;
@@ -462,6 +465,16 @@ static int rzg2l_dt_subnode_to_map(struct pinctrl_dev *pctldev,
 	maps[idx].data.mux.function = name;
 	idx++;
 
+	if (num_configs) {
+		ret = rzg2l_map_add_config(&maps[idx], name,
+					   PIN_MAP_TYPE_CONFIGS_GROUP,
+					   configs, num_configs);
+		if (ret < 0)
+			goto remove_group;
+
+		idx++;
+	}
+
 	dev_dbg(pctrl->dev, "Parsed %pOF with %d pins\n", np, num_pinmux);
 	ret = 0;
 	goto done;