x86/startup_64: Simplify calculation of initial page table address

Determining the address of the initial page table to program into CR3
involves:
- taking the physical address
- adding the SME encryption mask

On the primary entry path, the code is mapped using a 1:1 virtual to
physical translation, so the physical address can be taken directly
using a RIP-relative LEA instruction.

On the secondary entry path, the address can be obtained by taking the
offset from the virtual kernel base (__START_kernel_map) and adding the
physical kernel base.

This is implemented in a slightly confusing way, so clean this up.
Signed-off-by: Ard Biesheuvel <ardb@kernel.org>
Signed-off-by: Borislav Petkov (AMD) <bp@alien8.de>
Tested-by: Tom Lendacky <thomas.lendacky@amd.com>
Link: https://lore.kernel.org/r/20240227151907.387873-14-ardb+git@google.com

arch/x86/kernel/head_64.S

@@ -111,13 +111,11 @@ SYM_CODE_START_NOALIGN(startup_64)
 	call	__startup_64
 
 	/* Form the CR3 value being sure to include the CR3 modifier */
-	addq	$(early_top_pgt - __START_KERNEL_map), %rax
+	leaq	early_top_pgt(%rip), %rcx
+	addq	%rcx, %rax
 
 #ifdef CONFIG_AMD_MEM_ENCRYPT
 	mov	%rax, %rdi
-	mov	%rax, %r14
-
-	addq	phys_base(%rip), %rdi
 
 	/*
 	 * For SEV guests: Verify that the C-bit is correct. A malicious
@@ -126,12 +124,6 @@ SYM_CODE_START_NOALIGN(startup_64)
 	 * the next RET instruction.
 	 */
 	call	sev_verify_cbit
-
-	/*
-	 * Restore CR3 value without the phys_base which will be added
-	 * below, before writing %cr3.
-	 */
-	 mov	%r14, %rax
 #endif
 
 	jmp 1f
@@ -171,18 +163,18 @@ SYM_INNER_LABEL(secondary_startup_64_no_verify, SYM_L_GLOBAL)
 	/* Clear %R15 which holds the boot_params pointer on the boot CPU */
 	xorl	%r15d, %r15d
 
+	/* Derive the runtime physical address of init_top_pgt[] */
+	movq	phys_base(%rip), %rax
+	addq	$(init_top_pgt - __START_KERNEL_map), %rax
+
 	/*
 	 * Retrieve the modifier (SME encryption mask if SME is active) to be
 	 * added to the initial pgdir entry that will be programmed into CR3.
 	 */
 #ifdef CONFIG_AMD_MEM_ENCRYPT
-	movq	sme_me_mask, %rax
-#else
-	xorl	%eax, %eax
+	addq	sme_me_mask(%rip), %rax
 #endif
 
-	/* Form the CR3 value being sure to include the CR3 modifier */
-	addq	$(init_top_pgt - __START_KERNEL_map), %rax
 1:
 
 	/*
@@ -212,9 +204,6 @@ SYM_INNER_LABEL(secondary_startup_64_no_verify, SYM_L_GLOBAL)
 	btsl	$X86_CR4_PSE_BIT, %ecx
 	movq	%rcx, %cr4
 
-	/* Setup early boot stage 4-/5-level pagetables. */
-	addq	phys_base(%rip), %rax
-
 	/*
 	 * Switch to new page-table
 	 *