Merge series "spi: Set of cleanups" from Jay Fang <f.fangjian@huawei.com>:

Some cleanups of SPI drivers. No functional change.

Thanks,
Jay

Jay Fang (4):
  spi: ppc4xx: include <linux/io.h> instead of <asm/io.h>
  spi: omap-100k: Clean the value of 'status' is not used
  spi: delete repeated words in comments
  spi: spi-loopback-test: Fix 'tx_buf' might be 'rx_buf'

 drivers/spi/spi-bcm2835aux.c    | 2 +-
 drivers/spi/spi-dw-mmio.c       | 2 +-
 drivers/spi/spi-geni-qcom.c     | 4 ++--
 drivers/spi/spi-loopback-test.c | 2 +-
 drivers/spi/spi-omap-100k.c     | 2 --
 drivers/spi/spi-pl022.c         | 4 ++--
 drivers/spi/spi-ppc4xx.c        | 4 ++--
 7 files changed, 9 insertions(+), 11 deletions(-)

--
2.7.4

drivers/spi/spi-bcm2835aux.c

@@ -384,7 +384,7 @@ static int bcm2835aux_spi_transfer_one(struct spi_master *master,
 	bs->pending = 0;
 
 	/* Calculate the estimated time in us the transfer runs.  Note that
-	 * there are are 2 idle clocks cycles after each chunk getting
+	 * there are 2 idle clocks cycles after each chunk getting
 	 * transferred - in our case the chunk size is 3 bytes, so we
 	 * approximate this by 9 cycles/byte.  This is used to find the number
 	 * of Hz per byte per polling limit.  E.g., we can transfer 1 byte in

drivers/spi/spi-dw-mmio.c

@@ -56,7 +56,7 @@ struct dw_spi_mscc {
 /*
  * The Designware SPI controller (referred to as master in the documentation)
  * automatically deasserts chip select when the tx fifo is empty. The chip
- * selects then needs to be either driven as GPIOs or, for the first 4 using the
+ * selects then needs to be either driven as GPIOs or, for the first 4 using
  * the SPI boot controller registers. the final chip select is an OR gate
  * between the Designware SPI controller and the SPI boot controller.
  */

drivers/spi/spi-geni-qcom.c

@@ -639,8 +639,8 @@ static irqreturn_t geni_spi_isr(int irq, void *data)
 		complete(&mas->abort_done);
 
 	/*
-	 * It's safe or a good idea to Ack all of our our interrupts at the
-	 * end of the function. Specifically:
+	 * It's safe or a good idea to Ack all of our interrupts at the end
+	 * of the function. Specifically:
 	 * - M_CMD_DONE_EN / M_RX_FIFO_LAST_EN: Edge triggered interrupts and
 	 *   clearing Acks. Clearing at the end relies on nobody else having
 	 *   started a new transfer yet or else we could be clearing _their_

drivers/spi/spi-loopback-test.c

@@ -875,7 +875,7 @@ static int spi_test_run_iter(struct spi_device *spi,
 		test.transfers[i].len = len;
 		if (test.transfers[i].tx_buf)
 			test.transfers[i].tx_buf += tx_off;
-		if (test.transfers[i].tx_buf)
+		if (test.transfers[i].rx_buf)
 			test.transfers[i].rx_buf += rx_off;
 	}
 

drivers/spi/spi-omap-100k.c

@@ -296,7 +296,6 @@ static int omap1_spi100k_transfer_one_message(struct spi_master *master,
 
 	list_for_each_entry(t, &m->transfers, transfer_list) {
 		if (t->tx_buf == NULL && t->rx_buf == NULL && t->len) {
-			status = -EINVAL;
 			break;
 		}
 		status = omap1_spi100k_setup_transfer(spi, t);
@@ -315,7 +314,6 @@ static int omap1_spi100k_transfer_one_message(struct spi_master *master,
 			m->actual_length += count;
 
 			if (count != t->len) {
-				status = -EIO;
 				break;
 			}
 		}

drivers/spi/spi-pl022.c

@@ -288,7 +288,7 @@
 #define SPI_POLLING_TIMEOUT 1000
 
 /*
- * The type of reading going on on this chip
+ * The type of reading going on this chip
  */
 enum ssp_reading {
 	READING_NULL,
@@ -298,7 +298,7 @@ enum ssp_reading {
 };
 
 /*
- * The type of writing going on on this chip
+ * The type of writing going on this chip
  */
 enum ssp_writing {
 	WRITING_NULL,

drivers/spi/spi-ppc4xx.c

@@ -34,7 +34,7 @@
 #include <linux/spi/spi.h>
 #include <linux/spi/spi_bitbang.h>
 
-#include <asm/io.h>
+#include <linux/io.h>
 #include <asm/dcr.h>
 #include <asm/dcr-regs.h>
 
@@ -326,7 +326,7 @@ static void spi_ppc4xx_enable(struct ppc4xx_spi *hw)
 {
 	/*
 	 * On all 4xx PPC's the SPI bus is shared/multiplexed with
-	 * the 2nd I2C bus. We need to enable the the SPI bus before
+	 * the 2nd I2C bus. We need to enable the SPI bus before
 	 * using it.
 	 */