Commit d6f11e7d authored by Chen-Yu Tsai's avatar Chen-Yu Tsai Committed by Ulf Hansson

mmc: sunxi: Filter out unsupported modes declared in the device tree

The MMC device tree bindings include properties used to signal various
signalling speed modes. Until now the sunxi driver was accepting them
without any further filtering, while the sunxi device trees were not
actually using them.

Since some of the H5 boards can not run at higher speed modes stably,
we are resorting to declaring the higher speed modes per-board.

Regardless, having boards declare modes and blindly following them,
even without proper support in the driver, is generally a bad thing.

Filter out all unsupported modes from the capabilities mask after
the device tree properties have been parsed.

Cc: <stable@vger.kernel.org>
Signed-off-by: default avatarChen-Yu Tsai <wens@csie.org>
Acked-by: default avatarMaxime Ripard <maxime.ripard@bootlin.com>
Signed-off-by: default avatarUlf Hansson <ulf.hansson@linaro.org>
parent d49d92ac
...@@ -1415,6 +1415,21 @@ static int sunxi_mmc_probe(struct platform_device *pdev) ...@@ -1415,6 +1415,21 @@ static int sunxi_mmc_probe(struct platform_device *pdev)
if (ret) if (ret)
goto error_free_dma; goto error_free_dma;
/*
* If we don't support delay chains in the SoC, we can't use any
* of the higher speed modes. Mask them out in case the device
* tree specifies the properties for them, which gets added to
* the caps by mmc_of_parse() above.
*/
if (!(host->cfg->clk_delays || host->use_new_timings)) {
mmc->caps &= ~(MMC_CAP_3_3V_DDR | MMC_CAP_1_8V_DDR |
MMC_CAP_1_2V_DDR | MMC_CAP_UHS);
mmc->caps2 &= ~MMC_CAP2_HS200;
}
/* TODO: This driver doesn't support HS400 mode yet */
mmc->caps2 &= ~MMC_CAP2_HS400;
ret = sunxi_mmc_init_host(host); ret = sunxi_mmc_init_host(host);
if (ret) if (ret)
goto error_free_dma; goto error_free_dma;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment