arm64: dts: ls1046ardb: set RGMII interfaces to RGMII_ID mode

The correct setting for the RGMII ports on LS1046ARDB is to
enable delay on both Rx and Tx so the interface mode used must
be PHY_INTERFACE_MODE_RGMII_ID.

Since commit 1b3047b5 ("net: phy: realtek: add support for
configuring the RX delay on RTL8211F") the Realtek 8211F PHY driver
has control over the RGMII RX delay and it is disabling it for
RGMII_TXID. The LS1046ARDB uses two such PHYs in RGMII_ID mode but
in the device tree the mode was described as "rgmii".

Changing the phy-connection-type to "rgmii-id" to address the issue.

Fixes: 3fa395d2 ("arm64: dts: add LS1046A DPAA FMan nodes")
Signed-off-by: Madalin Bucur <madalin.bucur@oss.nxp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts

@@ -131,12 +131,12 @@ &usb1 {
 &fman0 {
 	ethernet@e4000 {
 		phy-handle = <&rgmii_phy1>;
-		phy-connection-type = "rgmii";
+		phy-connection-type = "rgmii-id";
 	};
 
 	ethernet@e6000 {
 		phy-handle = <&rgmii_phy2>;
-		phy-connection-type = "rgmii";
+		phy-connection-type = "rgmii-id";
 	};
 
 	ethernet@e8000 {