thermal: imx: Use driver's local data to decide whether to run a measurement

Use driver's local data to evaluate the need to run or not to run a
measurement.
Signed-off-by: Andrzej Pietrasiewicz <andrzej.p@collabora.com>
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Link: https://lore.kernel.org/r/20200703104354.19657-3-andrzej.p@collabora.com

drivers/thermal/imx_thermal.c

@@ -252,10 +252,11 @@ static int imx_get_temp(struct thermal_zone_device *tz, int *temp)
 	const struct thermal_soc_data *soc_data = data->socdata;
 	struct regmap *map = data->tempmon;
 	unsigned int n_meas;
-	bool wait;
+	bool wait, run_measurement;
 	u32 val;
 
-	if (thermal_zone_device_is_enabled(tz)) {
+	run_measurement = !data->irq_enabled;
+	if (!run_measurement) {
 		/* Check if a measurement is currently in progress */
 		regmap_read(map, soc_data->temp_data, &val);
 		wait = !(val & soc_data->temp_valid_mask);
@@ -282,7 +283,7 @@ static int imx_get_temp(struct thermal_zone_device *tz, int *temp)
 
 	regmap_read(map, soc_data->temp_data, &val);
 
-	if (!thermal_zone_device_is_enabled(tz)) {
+	if (run_measurement) {
 		regmap_write(map, soc_data->sensor_ctrl + REG_CLR,
 			     soc_data->measure_temp_mask);
 		regmap_write(map, soc_data->sensor_ctrl + REG_SET,