net: dsa: microchip: use collision based back pressure mode

Errata DS80000758 states that carrier sense back pressure mode can cause
link down issues in 100BASE-TX half duplex mode. The datasheet also
recommends to always use the collision based back pressure mode.

Fixes: b987e98e ("dsa: add DSA switch driver for Microchip KSZ9477")
Signed-off-by: Enguerrand de Ribaucourt <enguerrand.de-ribaucourt@savoirfairelinux.com>
Reviewed-by: Woojung Huh <Woojung.huh@microchip.com>
Acked-by: Arun Ramadoss <arun.ramadoss@microchip.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/dsa/microchip/ksz9477.c

@@ -1297,6 +1297,10 @@ int ksz9477_setup(struct dsa_switch *ds)
 	/* Enable REG_SW_MTU__2 reg by setting SW_JUMBO_PACKET */
 	ksz_cfg(dev, REG_SW_MAC_CTRL_1, SW_JUMBO_PACKET, true);
 
+	/* Use collision based back pressure mode. */
+	ksz_cfg(dev, REG_SW_MAC_CTRL_1, SW_BACK_PRESSURE,
+		SW_BACK_PRESSURE_COLLISION);
+
 	/* Now we can configure default MTU value */
 	ret = regmap_update_bits(ksz_regmap_16(dev), REG_SW_MTU__2, REG_SW_MTU_MASK,
 				 VLAN_ETH_FRAME_LEN + ETH_FCS_LEN);

drivers/net/dsa/microchip/ksz9477_reg.h

@@ -247,6 +247,7 @@
 #define REG_SW_MAC_CTRL_1		0x0331
 
 #define SW_BACK_PRESSURE		BIT(5)
+#define SW_BACK_PRESSURE_COLLISION	0
 #define FAIR_FLOW_CTRL			BIT(4)
 #define NO_EXC_COLLISION_DROP		BIT(3)
 #define SW_JUMBO_PACKET			BIT(2)