[media] media: i2c: ths7303: remove init_enable option from pdata

This patch removes init_enable option from pdata, the init_enable
was intended that the device should start streaming video immediately
but ideally the bridge drivers should call s_stream explicitly for such
devices to start video.
Signed-off-by: Lad, Prabhakar <prabhakar.csengg@gmail.com>
Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>

drivers/media/i2c/ths7303.c

@@ -356,9 +356,7 @@ static int ths7303_setup(struct v4l2_subdev *sd)
 	int ret;
 	u8 mask;
 
-	state->stream_on = pdata->init_enable;
-
-	mask = state->stream_on ? 0xff : 0xf8;
+	mask = 0xf8;
 
 	ret = ths7303_write(sd, THS7303_CHANNEL_1, pdata->ch_1 & mask);
 	if (ret)

include/media/ths7303.h

@@ -30,13 +30,11 @@
  * @ch_1: Bias value for channel one.
  * @ch_2: Bias value for channel two.
  * @ch_3: Bias value for channel three.
- * @init_enable: initalize on init.
  */
 struct ths7303_platform_data {
 	u8 ch_1;
 	u8 ch_2;
 	u8 ch_3;
-	u8 init_enable;
 };
 
 #endif