Commit da6b21e9 authored by Krzysztof Kozlowski's avatar Krzysztof Kozlowski

ARM: Drop fixed 200 Hz timer requirement from Samsung platforms

All Samsung platforms, including the Exynos, are selecting HZ_FIXED with
200 Hz.  Unfortunately in case of multiplatform image this affects also
other platforms when Exynos is enabled.

This looks like an very old legacy code, dating back to initial
upstreaming of S3C24xx.  Probably it was required for s3c24xx timer
driver, which was removed in commit ad38bdd1 ("ARM: SAMSUNG: Remove
unused plat-samsung/time.c").

Since then, this fixed 200 Hz spread everywhere, including out-of-tree
Samsung kernels (SoC vendor's and Tizen's).  I believe this choice
was rather an effect of coincidence instead of conscious choice.

On S3C24xx, the PWM counter is only 16 bit wide, and with the
typical 12MHz input clock that overflows every 5.5ms.  This works
with HZ=200 or higher but not with HZ=100 which needs a 10ms
interval between ticks.  On Later chips (S3C64xx, S5P and EXYNOS),
the counter is 32 bits and does not have this problem.

The new samsung_pwm_timer driver solves the problem by scaling the input
clock by a factor of 50 on S3C24xx, which makes it less accurate but
allows HZ=100 as well as CONFIG_NO_HZ with fewer wakeups.

Few perf mem and sched tests on Odroid XU3 board (Exynos5422, 4x Cortex
A7, 4x Cortex A15) show no regressions when switching from 200 Hz to
other values.
Reported-by: default avatarLee Jones <lee.jones@linaro.org>
[Dropping of 200_HZ from S3C/S5P was suggested by Arnd]
Reported-by: default avatarArnd Bergmann <arnd@arndb.de>
Cc: Kukjin Kim <kgene@kernel.org>
Signed-off-by: default avatarKrzysztof Kozlowski <krzk@kernel.org>
[Tested on Exynos5800]
Tested-by: default avatarJavier Martinez Canillas <javier@osg.samsung.com>
Acked-by: default avatarKukjin Kim <kgene@kernel.org>
[Tested on S3C2440]
Tested-by: default avatarSylwester Nawrocki <s.nawrocki@samsung.com>
Acked-by: default avatarLee Jones <lee.jones@linaro.org>
parent 9d56d6cb
...@@ -1496,8 +1496,7 @@ source kernel/Kconfig.preempt ...@@ -1496,8 +1496,7 @@ source kernel/Kconfig.preempt
config HZ_FIXED config HZ_FIXED
int int
default 200 if ARCH_EBSA110 || ARCH_S3C24XX || \ default 200 if ARCH_EBSA110
ARCH_S5PV210 || ARCH_EXYNOS4
default 128 if SOC_AT91RM9200 default 128 if SOC_AT91RM9200
default 0 default 0
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment