Commit dac5488a authored by Stephen M. Cameron's avatar Stephen M. Cameron Committed by Jens Axboe

cciss: remove board_id parameter from cciss_interrupt_mode()

cciss: remove board_id parameter from cciss_interrupt_mode()
Signed-off-by: default avatarStephen M. Cameron <scameron@beardog.cce.hp.com>
Signed-off-by: default avatarJens Axboe <jaxboe@fusionio.com>
parent dd9c426e
......@@ -199,7 +199,7 @@ static void cciss_geometry_inquiry(int ctlr, int logvol,
sector_t total_size,
unsigned int block_size, InquiryData_struct *inq_buff,
drive_info_struct *drv);
static void __devinit cciss_interrupt_mode(ctlr_info_t *, __u32);
static void __devinit cciss_interrupt_mode(ctlr_info_t *);
static void start_io(ctlr_info_t *h);
static int sendcmd_withirq(__u8 cmd, int ctlr, void *buff, size_t size,
__u8 page_code, unsigned char scsi3addr[],
......@@ -3932,7 +3932,7 @@ cciss_put_controller_into_performant_mode(ctlr_info_t *h)
* controllers that are capable. If not, we use IO-APIC mode.
*/
static void __devinit cciss_interrupt_mode(ctlr_info_t *c, __u32 board_id)
static void __devinit cciss_interrupt_mode(ctlr_info_t *c)
{
#ifdef CONFIG_PCI_MSI
int err;
......@@ -3941,9 +3941,8 @@ static void __devinit cciss_interrupt_mode(ctlr_info_t *c, __u32 board_id)
};
/* Some boards advertise MSI but don't really support it */
if ((board_id == 0x40700E11) ||
(board_id == 0x40800E11) ||
(board_id == 0x40820E11) || (board_id == 0x40830E11))
if ((c->board_id == 0x40700E11) || (c->board_id == 0x40800E11) ||
(c->board_id == 0x40820E11) || (c->board_id == 0x40830E11))
goto default_int_mode;
if (pci_find_capability(c->pdev, PCI_CAP_ID_MSIX)) {
......@@ -4052,7 +4051,7 @@ static int __devinit cciss_pci_init(ctlr_info_t *c)
/* If the kernel supports MSI/MSI-X we will try to enable that functionality,
* else we use the IO-APIC interrupt assigned to us by system ROM.
*/
cciss_interrupt_mode(c, c->board_id);
cciss_interrupt_mode(c);
/* find the memory BAR */
for (i = 0; i < DEVICE_COUNT_RESOURCE; i++) {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment