Commit dd7d9052 authored by Dan Murphy's avatar Dan Murphy Committed by Mark Brown

ASoC: tas2770: Remove ti,asi-format code

Remove the code to support the asi-format binding property. The code
does nothing except read the property and set a variable. No additional
action is taken except to reset the variable. The property is supposed
to set the rising or falling RX edge detection of the SBCLK but this
edge detection is done by checking the DAI_FMT_INV_MASK.
Signed-off-by: default avatarDan Murphy <dmurphy@ti.com>
Link: https://lore.kernel.org/r/20200923132600.10652-5-dmurphy@ti.comSigned-off-by: default avatarMark Brown <broonie@kernel.org>
parent c0a30e2e
...@@ -391,8 +391,6 @@ static int tas2770_set_fmt(struct snd_soc_dai *dai, unsigned int fmt) ...@@ -391,8 +391,6 @@ static int tas2770_set_fmt(struct snd_soc_dai *dai, unsigned int fmt)
if (ret < 0) if (ret < 0)
return ret; return ret;
tas2770->asi_format = fmt;
return 0; return 0;
} }
...@@ -646,15 +644,6 @@ static int tas2770_parse_dt(struct device *dev, struct tas2770_priv *tas2770) ...@@ -646,15 +644,6 @@ static int tas2770_parse_dt(struct device *dev, struct tas2770_priv *tas2770)
{ {
int rc = 0; int rc = 0;
rc = fwnode_property_read_u32(dev->fwnode, "ti,asi-format",
&tas2770->asi_format);
if (rc) {
dev_info(tas2770->dev, "Property %s is missing setting default slot\n",
"ti,asi-format");
tas2770->asi_format = 0;
}
rc = fwnode_property_read_u32(dev->fwnode, "ti,imon-slot-no", rc = fwnode_property_read_u32(dev->fwnode, "ti,imon-slot-no",
&tas2770->i_sense_slot); &tas2770->i_sense_slot);
if (rc) { if (rc) {
......
...@@ -132,7 +132,6 @@ struct tas2770_priv { ...@@ -132,7 +132,6 @@ struct tas2770_priv {
struct regmap *regmap; struct regmap *regmap;
struct snd_soc_component *component; struct snd_soc_component *component;
int power_state; int power_state;
int asi_format;
struct gpio_desc *reset_gpio; struct gpio_desc *reset_gpio;
struct gpio_desc *sdz_gpio; struct gpio_desc *sdz_gpio;
int sampling_rate; int sampling_rate;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment