Commit dd8cdc9e authored by Srinivas Kandagatla's avatar Srinivas Kandagatla Committed by Andy Gross

arm64: dts: qcom: apq8016-sbc: add usb support

Signed-off-by: default avatarSrinivas Kandagatla <srinivas.kandagatla@linaro.org>
parent 2a0bc810
......@@ -10,4 +10,18 @@ pinconf {
output-low;
};
};
usb_id_default: usb-id-default {
pinmux {
function = "gpio";
pins = "gpio121";
};
pinconf {
pins = "gpio121";
drive-strength = <8>;
input-enable;
bias-pull-up;
};
};
};
......@@ -139,6 +139,40 @@ sdhci@07824000 {
pinctrl-1 = <&sdc1_clk_off &sdc1_cmd_off &sdc1_data_off>;
status = "okay";
};
usb@78d9000 {
extcon = <&usb_id>, <&usb_id>;
status = "okay";
};
ehci@78d9000 {
status = "okay";
};
phy@78d9000 {
v1p8-supply = <&pm8916_l7>;
v3p3-supply = <&pm8916_l13>;
vddcx-supply = <&pm8916_s1>;
extcon = <&usb_id>, <&usb_id>;
dr_mode = "otg";
status = "okay";
switch-gpio = <&pm8916_gpios 4 GPIO_ACTIVE_HIGH>;
pinctrl-names = "default";
pinctrl-0 = <&usb_sw_sel_pm>;
};
};
usb2513 {
compatible = "smsc,usb3503";
reset-gpios = <&pm8916_gpios 3 GPIO_ACTIVE_LOW>;
initial-mode = <1>;
};
usb_id: usb-id {
compatible = "linux,extcon-usb-gpio";
id-gpio = <&msmgpio 121 GPIO_ACTIVE_HIGH>;
pinctrl-names = "default";
pinctrl-0 = <&usb_id_default>;
};
};
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment