[media] nuvoton-cir: Don't touch PS/2 interrupts while initializing

There are reports[1] that on some motherboards loading the nuvoton-cir
disables PS/2 keyboard input. This is caused by an erroneous write of
CIR_INTR_MOUSE_IRQ_BIT to ACPI control register.

According to datasheet the write enables mouse power management event
interrupts which will probably have ill effects if the motherboard has
only one PS/2 port with keyboard in it.

The cir hardware does not need mouse interrupts to function and should
not touch them. This patch removes the illegal writes and registry
definitions.

[1] http://ubuntuforums.org/showthread.php?t=2106277&p=12461912&mode=threaded#post12461912Reported-by: Bruno Maire <bruno.maire@besonet.ch>
Tested-by: Bruno Maire <bruno.maire@besonet.ch>
Signed-off-by: Antti Seppälä <a.seppala@gmail.com>
Acked-by: Jarod Wilson <jarod@redhat.com>
Signed-off-by: Mauro Carvalho Chehab <m.chehab@samsung.com>

drivers/media/rc/nuvoton-cir.c

@@ -330,9 +330,6 @@ static void nvt_cir_wake_ldev_init(struct nvt_dev *nvt)
 	/* Enable CIR Wake via PSOUT# (Pin60) */
 	nvt_set_reg_bit(nvt, CIR_WAKE_ENABLE_BIT, CR_ACPI_CIR_WAKE);
 
-	/* enable cir interrupt of mouse/keyboard IRQ event */
-	nvt_set_reg_bit(nvt, CIR_INTR_MOUSE_IRQ_BIT, CR_ACPI_IRQ_EVENTS);
-
 	/* enable pme interrupt of cir wakeup event */
 	nvt_set_reg_bit(nvt, PME_INTR_CIR_PASS_BIT, CR_ACPI_IRQ_EVENTS2);
 
@@ -456,7 +453,6 @@ static void nvt_enable_wake(struct nvt_dev *nvt)
 
 	nvt_select_logical_dev(nvt, LOGICAL_DEV_ACPI);
 	nvt_set_reg_bit(nvt, CIR_WAKE_ENABLE_BIT, CR_ACPI_CIR_WAKE);
-	nvt_set_reg_bit(nvt, CIR_INTR_MOUSE_IRQ_BIT, CR_ACPI_IRQ_EVENTS);
 	nvt_set_reg_bit(nvt, PME_INTR_CIR_PASS_BIT, CR_ACPI_IRQ_EVENTS2);
 
 	nvt_select_logical_dev(nvt, LOGICAL_DEV_CIR_WAKE);

drivers/media/rc/nuvoton-cir.h

@@ -363,7 +363,6 @@ struct nvt_dev {
 #define LOGICAL_DEV_ENABLE	0x01
 
 #define CIR_WAKE_ENABLE_BIT	0x08
-#define CIR_INTR_MOUSE_IRQ_BIT	0x80
 #define PME_INTR_CIR_PASS_BIT	0x08
 
 /* w83677hg CIR pin config */