ARM: dts: add on-board INA231 sensors for exynos5422-odroidxu3

The odroid-xu3 has 4 INA231 current sensors on board which can be
accessed from the Linux via the hwmon interface.

There is one sensor for each of these power rails:

- A15 cluster: VDD_ARM
- A7 cluster: VDD_KFC
- GPU: VDD_G3D
- memory: VDD_MEM

In addition to adding the sensors, LDO26 from the PMIC needs to be
enabled because it's powering these sensor.

Cc: Javier Martinez Canillas <javier.martinez@collabora.co.uk>
Cc: Sjoerd Simons <sjoerd.simons@collabora.co.uk>
Reviewed-by: Sjoerd Simons <sjoerd.simons@collabora.co.uk>
Signed-off-by: Kevin Hilman <khilman@linaro.org>
Signed-off-by: Kukjin Kim <kgene@kernel.org>

arch/arm/boot/dts/exynos5422-odroidxu3.dts

@@ -174,6 +174,13 @@ ldo24_reg: LDO24 {
 					regulator-always-on;
 				};
 
+				ldo26_reg: LDO26 {
+					regulator-name = "vdd_ldo26";
+					regulator-min-microvolt = <3000000>;
+					regulator-max-microvolt = <3000000>;
+					regulator-always-on;
+				};
+
 				buck1_reg: BUCK1 {
 					regulator-name = "vdd_mif";
 					regulator-min-microvolt = <800000>;
@@ -330,3 +337,35 @@ &usbdrd_dwc3_0 {
 &usbdrd_dwc3_1 {
 	dr_mode = "otg";
 };
+
+&i2c_0 {
+	status = "okay";
+
+	/* A15 cluster: VDD_ARM */
+	ina231@40 {
+		compatible = "ti,ina231";
+		reg = <0x40>;
+		shunt-resistor = <10000>;
+	};
+
+	/* memory: VDD_MEM */
+	ina231@41 {
+		compatible = "ti,ina231";
+		reg = <0x41>;
+		shunt-resistor = <10000>;
+	};
+
+	/* GPU: VDD_G3D */
+	ina231@44 {
+		compatible = "ti,ina231";
+		reg = <0x44>;
+		shunt-resistor = <10000>;
+	};
+
+	/* A7 cluster: VDD_KFC */
+	ina231@45 {
+		compatible = "ti,ina231";
+		reg = <0x45>;
+		shunt-resistor = <10000>;
+	};
+};