net: macb: fix random memory corruption on RX with 64-bit DMA

64-bit DMA addresses are split in upper and lower halves that are
written in separate fields on GEM. For RX, bit 0 of the address is used
as the ownership bit (RX_USED). When the RX_USED bit is unset the
controller is allowed to write data to the buffer.

The driver does not guarantee that the controller already sees the upper
half when the RX_USED bit is cleared, possibly resulting in the
controller writing an incoming frame to an address with an incorrect
upper half and therefore possibly corrupting unrelated system memory.

Fix that by adding the necessary DMA memory barrier between the writes.

This corruption was observed on a ZynqMP based system.

Fixes: fff8019a ("net: macb: Add 64 bit addressing support for GEM")
Signed-off-by: Anssi Hannula <anssi.hannula@bitwise.fi>
Acked-by: Harini Katakam <harini.katakam@xilinx.com>
Tested-by: Claudiu Beznea <claudiu.beznea@microchip.com>
Cc: Nicolas Ferre <nicolas.ferre@microchip.com>
Cc: Michal Simek <michal.simek@xilinx.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/cadence/macb_main.c

@@ -681,6 +681,11 @@ static void macb_set_addr(struct macb *bp, struct macb_dma_desc *desc, dma_addr_
 	if (bp->hw_dma_cap & HW_DMA_CAP_64B) {
 		desc_64 = macb_64b_desc(bp, desc);
 		desc_64->addrh = upper_32_bits(addr);
+		/* The low bits of RX address contain the RX_USED bit, clearing
+		 * of which allows packet RX. Make sure the high bits are also
+		 * visible to HW at that point.
+		 */
+		dma_wmb();
 	}
 #endif
 	desc->addr = lower_32_bits(addr);