s390/vfio-ap: handle queue state change in progress on reset

A new APQSW response code (0xA) indicating the designated queue is in the
process of being bound or associated to a configuration may be returned
from the PQAP(ZAPQ) command. This patch introduces code that will verify
when the PQAP(ZAPQ) command can be re-issued after receiving response code
0xA.
Signed-off-by: Tony Krowiak <akrowiak@linux.ibm.com>
Reviewed-by: Jason J. Herne <jjherne@linux.ibm.com>
Acked-by: Halil Pasic <pasic@linux.ibm.com>
Tested-by: Viktor Mihajlovski <mihajlov@linux.ibm.com>
Link: https://lore.kernel.org/r/20230815184333.6554-9-akrowiak@linux.ibm.comSigned-off-by: Heiko Carstens <hca@linux.ibm.com>

drivers/s390/crypto/vfio_ap_ops.c

@@ -1647,7 +1647,8 @@ static void apq_reset_check(struct work_struct *reset_work)
 					      status.irq_enabled);
 		} else {
 			if (q->reset_status.response_code == AP_RESPONSE_RESET_IN_PROGRESS ||
-			    q->reset_status.response_code == AP_RESPONSE_BUSY) {
+			    q->reset_status.response_code == AP_RESPONSE_BUSY ||
+			    q->reset_status.response_code == AP_RESPONSE_STATE_CHANGE_IN_PROGRESS) {
 				status = ap_zapq(q->apqn, 0);
 				memcpy(&q->reset_status, &status, sizeof(status));
 				continue;
@@ -1679,6 +1680,7 @@ static void vfio_ap_mdev_reset_queue(struct vfio_ap_queue *q)
 	case AP_RESPONSE_NORMAL:
 	case AP_RESPONSE_RESET_IN_PROGRESS:
 	case AP_RESPONSE_BUSY:
+	case AP_RESPONSE_STATE_CHANGE_IN_PROGRESS:
 		/*
 		 * Let's verify whether the ZAPQ completed successfully on a work queue.
 		 */