ARM: dts: imx7s-warp: add ov2680 sensor node

Warp7 comes with a Omnivision OV2680 sensor, add the node here to make
complete the camera data path for this system. Add the needed regulator
to the analog voltage supply, the port and endpoints in mipi_csi node
and the pinctrl for the reset gpio.
Signed-off-by: Rui Miguel Silva <rui.silva@linaro.org>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

arch/arm/boot/dts/imx7s-warp.dts

@@ -55,6 +55,14 @@ reg_bt: regulator-bt {
 		regulator-always-on;
 	};
 
+	reg_peri_3p15v: regulator-peri-3p15v {
+		compatible = "regulator-fixed";
+		regulator-name = "peri_3p15v_reg";
+		regulator-min-microvolt = <3150000>;
+		regulator-max-microvolt = <3150000>;
+		regulator-always-on;
+	};
+
 	sound {
 		compatible = "simple-audio-card";
 		simple-audio-card,name = "imx7-sgtl5000";
@@ -184,6 +192,27 @@ &i2c2 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_i2c2>;
 	status = "okay";
+
+	ov2680: camera@36 {
+		compatible = "ovti,ov2680";
+		pinctrl-names = "default";
+		pinctrl-0 = <&pinctrl_ov2680>;
+		reg = <0x36>;
+		clocks = <&osc>;
+		clock-names = "xvclk";
+		reset-gpios = <&gpio1 3 GPIO_ACTIVE_LOW>;
+		DOVDD-supply = <&sw2_reg>;
+		DVDD-supply = <&sw2_reg>;
+		AVDD-supply = <&reg_peri_3p15v>;
+
+		port {
+			ov2680_to_mipi: endpoint {
+				remote-endpoint = <&mipi_from_sensor>;
+				clock-lanes = <0>;
+				data-lanes = <1>;
+			};
+		};
+	};
 };
 
 &i2c3 {
@@ -221,6 +250,16 @@ &mipi_csi {
 	clock-frequency = <166000000>;
 	fsl,csis-hs-settle = <3>;
 	status = "okay";
+
+	port@0 {
+		reg = <0>;
+
+		mipi_from_sensor: endpoint {
+			remote-endpoint = <&ov2680_to_mipi>;
+			data-lanes = <1>;
+		};
+
+	};
 };
 
 &sai1 {
@@ -347,6 +386,12 @@ MX7D_PAD_I2C4_SDA__I2C4_SDA	0x4000007f
 		>;
 	};
 
+	pinctrl_ov2680: ov2660grp {
+		fsl,pins = <
+			MX7D_PAD_LPSR_GPIO1_IO03__GPIO1_IO3	0x14
+		>;
+	};
+
 	pinctrl_sai1: sai1grp {
 		fsl,pins = <
 			MX7D_PAD_SAI1_RX_DATA__SAI1_RX_DATA0	0x1f